What do boat building, repairing, restoring people do in bad weather? Are there boat-related activities?

Question:
that can be conducted indoors in an area too small to fit the entire boat? What sorts of things eg hardware, woodwork, plumbing engine, electrical can be worked on separately and then installed later? Curtains will be made off site. What else?

Answers:

Do I need a drivers license to drive a boat in florida?

There are plenty of indoor spaces large enough for several large boats. There is plenty of indoor jobs available.

Where is the identification number on the Reo pick-ups 650 and 450?

Theres always somthing that can be done on a boat, I was out there in an ice storm the other day, pulling huge chunks of ice left by a Nor' easter that blew through here (Long Island) a few days ago, it was weighing down the cover, and needed to be cleared before it ripped it, normally water rolls off but, the heavy wet snow ind ice made it sag, it froze and i was throwing 200 lb blocks of ice over the side, and they were smashing in the drive way, then THAT FROZE SOLID. The whole Island looks like a glacier with all the ice, I had to wear cleats (yak trax) just to walk around without falling, emergency rooms are full of broken bones from falls, everybody fell, you can't walk on frozen windswept snow that has turned to ice.

Where to buy a ACRO PROP Local to Looe?

In commercial yards we work through the bad weather. Only torrential downpours and MAJOR storms stop most/all work. If we can't keep the power on we can't work. (Also if there's an evacuation in effect we stop work and get out of the way!)

Alum-boat.Toon Brite clnr worked grt! Polish is difficult! What is your easiest favorite alum. polish?


You can't weld or paint in the rain, but there are plenty of dry areas where people can work. Below deck - in the tanks, or in the accommodations you can weld - as long as the machine and the operator are out of the water (water + electricity = trouble).

What is the best and cheapest way to ship a 16 foot canoe to the US from Ontario Canada?


HVAC work can be done in bad weather, engine room work, joinery work; all these things are in the dry spaces inside the vessel. Piping can be "pre-fabbed" and then installed, as can hand rails, walkways and platforms.

Are cyclops sexier with contacts or a monocle?


You can also take weather days to catch up on planning and/or paperwork.
More Questions & Answers ...

  • I sail vanguard lasers i was just wondering who else might i would like to talk.?
  • Need x-ref of Evinrude & Johnson Model #'s to Years...?
  • How much should I pay for a new 90 or 115 4 stroke outboard motor for my 19' center consile Key West boat?
  • Do you need a permit to take a inflatable boat with outboard in the sea or on a river the inflatable is 4.2 m?
  • My boat is turnning over slow and i don't think it is the battery could it be the fuel line or filter?
  • Every small marine craft I ever piloted had a PFD for the passengers. Why not parachutes for GA passengers?
  • When a boat is registered under the "full British ship's registry" in England, why do they quote 64/64 shares
  • How to determine the test prossure for a pipe line?
  • Which brand is providing power yachts within budget ,, a small one ?
  • What's the quickest way to sell a 2004 pacifica & 2006 boat that go together?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.