Question:
Answers:
My aluminum boat and motor stay in the water all year. What can I use to dissolve the lime deposits on it ?
the first response is correct. Remove screw at bottom and then remove screw at top of outdrive and resevoir cap. Go to your marine supply dealer and you will need 2qts of merc hi performance lower unit oil and also purchase the pump for it as it has fitting to screw into lower screw hole that makes it less messy. Always fill from bottom screw hole to top so that as it fills it purges the air up and out.Once it starts to come out top hole put top screw in then remove pump and put bottom screw in . Then get in boat and top off oil in resevoir . After running boat double check resevoir.and your good to go
What ( marine) gps in the $1,000. range is the most user friendly?
a silver screw in the bottom of the outdrive. put the drive unit as "straight" down as you can. on the engine is a small plastic bottle with green oil in it. remove the screw, then take the top off the reservoir(bottle). it takes a while, be patient. to fill, put the oil in the bottom 'til you reach the full mark on the reservoir.
More Questions & Answers ...How much fuel does an ice breaking ship use?
Boat won't pick up speed?
What requirements are there for commercial use of a boat in Michigan?
Boat owners?
The hoot skiff?
Pittsburgh Boating?
Where can I rent/buy a boat trailer that can hold a 42' sailboat? (Links, phone numbers)?
Subs. i have seen tiny subs go down to the bottom of the ocean deepest parts on tv .?
What is the cost to moor a 44ft. saliboat in Marina Del Rey these days?
What is a good boat to buy to use as a ski rental?
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.