Question:
I have a honda 9.9 extra long shaft. I know where the impeller is located, but am not able to get there. I have removed the 4 bolts from the seperator extension as well as the 4 bolts attaching the lower section(this section includes the prop) to the seperator ext.
In spite of this I am not able to seperat the sections to gain access to the impellar housing. I have tapped on each section w/a rubber mallet which has not helped. Do I need to do anything w/ the gear shift linkage? Suggestions/instructions/guida... please. Thanks.
Answers:
wot the best way 2 paint my fibreglass boat as dont no wot paint is on there allready?
look at the forward part of the lower unit. see a barrel nut and a lock nut. 10mm. loosen and screw the barrel nut up...that should do it. i usually charge for correct answers. yuk!!on a 24foot walkaround what is cheaper to operate a v8 I/o or a 250 outboard?
too bad. that sucks for youHow can I obtain ownership of a boat that has been on my property for over nine months?
contact www.theoutboardwizard.com... free tech helpwhat is self lubricating bearing?
i have a merc 9.9 long shaft i will go look..........brings back memories of replacing my impeller. You are right the linkage has to come apart look about half way up shaft and you should find a round plastic cover, pop that inside you have one linkage coming from the lower unit and a linkage going down to were this round cover is. there is a small block with two holes that these linkages are locked into note.. mark linkage with black sharpie maybe even take a dig pic for handy reference. i have found it is easier to have the motor on its side. Should slip right out now good luckMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.