Question:
or do I have to buy the ones from best buy?
Answers:
what kind of amp kit do i need if i have one 2 ohm amp and one 1 ohm amp.?
If you are on a budget, then yes, you can. You will need to buy a High to low converter. What this will do, is take the high level outputs (speaker level) of your factory radio, and make them low level outputs (RCA level). There are a few different types, some fancy, some generic. One allows you to adjust the gain levels, or adjust the voltage input levels to your amp. The other will not, it will just give you low level for the input of your amp, then the amp gain will increase your sound. Others will even have a remote turn on bult in, that you can connect directly to your amp, so you don't have to run an extra wire from your head unit. You can install one of these without removing the head unit. All you need to do is use your existing rear speaker wires, and hook them to the high to low converter. Of course, I am assuming you are putting the sub in the back of the vehicle.does any 1 have the radio code for a ford 5000 rds eon , M014572 , flat battrey .. Thank you ...?
Once this is done, you can run your RCA wires from the high to low converter, to the amp. Just make sure your amp is wired correctly and you use the correct type of wiring. If your amp doesn't have a built in crossover, I'd suggest buying a cheapy. I'd suggest a single low pass crossover with some type of bass gain. This will increase the bass response from the sub, making it sound louder.
Now please keep in mind, this can work, but you gain more for your sound by changing out your factory head unit and buying an aftermarket one, but it's not necessary. I started the same way, till I was able to afford something better.
Ok, another Car stereo question!?
Hope this helps out.
Good Luck!
Dual or Jensen?(For indash recievers)?
depends on what kinda stereo came stock in the car....Would a sub that's ported rated at 200rms watts powered by 200rms amp be enough to really BOOM?
Crutchfield offers such integration devices. Personally, I wouldnt stick with a stock head unit.Car navigation systems, any recommendations?
it all depends on the component supplied by the car manufacturer.i need a 2 channel 2000 watt amp an advice?
you have to have additional component outlets, power is easy enough to get but cutting into the wires on the OEM equipment from the car is probably unwise. if you cause a short, you might void the dealerships responsibility to warrant electrical problems.
Listen to iPod on a 1998 Mercedes-Benz ML320 using an after-market adaptor?
Depends on how the stock head unit is set up. If it came with RCA Jacks then you should be all set. If not then you should go to a car audio store and pick out a decent head unit that fits your needs.What is wrong with my car's CD player?
line level convertersDon't be cheap take the stock radio out and throw in something that will give you sound
What type of kicker amp is good with kicker L7?
Yes - it can.how do i get a radio check on my cb radio?
Use amps that have "line level" or "high impedance" inputs. You can wire your factory head "outs" directly into the amp.
Does anyone know how to tune a CB antenna?
This is how I have my system set-up - factory Delco head driving Pioneer amps and Infinity speakers.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.