Question:
i bolted my lic plate tight to the car, but the trunk still vibrates from all the bass. No i do not want to get dynmat.
Answers:
If you had the choice what subs and amps would you choose out of these?
well subs are hard to stop vibration especially in the trunk IF u are not going to get Dynmat or any rubber insulation to keep out the sound the only options u have are turning the subs in a different direction/ or moving them so that the vibrations dont hit certain areas of the trunk so bad..Or to tweak your amp so there is less vibrations in the speakers when the bass is thumping...Also check to make sure the box/enclosure is sealed tightly to prevent any sound leakage .much luckI want to add bass to my 02 Nissan Altima?
is it just the plastic stuff in the trunk or the whole thing?What's the good sound set-up for d kia pride but has a cheaper price?
You're going to need to find the source. Crank it up and put pressure on anything that might rattle (jack, bumper, tail light...) unitl you find the source. Then tighten everything down and use rubber gaskets/insulation to dampen the rattle. Good luck, this is a headache job, but worth it when it's done.a vehicle harrness thingy
Ford focus stereo face detachable?
The vibration is caused by the friction of 2 pieces of metal.How do i connect my main speakers in my car to the amp -best way-?
You need to isolate where the vibration is coming from and then either A) screw down the area tighter or B) foam it up so it doesnt rattle
I cant turn on a power amp for the car ,,,remote??
Another option is to use expanda foam
but if u still have rattles then just dont turn it up, or turn ur bass down on ur head unit
it will be hard to stop ALL of the rattle without something like dynamat, if its still the plate you can just get a dynamat lic plate kit which is only around $10 and gives you a small piece of dyna to put behind the plate
How can I connect my Garmin GPS to my car stereo so it interrupts my music when it says a command?
If your worried about the cost of Dynamat, Tar paper is almost the same thing. But after building several cars I can say Dynamat is the best. What your looking for is something that's going to make the trunk lid for example, heavyer. Something that's not going to allow sound to transform into vibration. Dyanamat can be cut into smaller pieces and used in between the folds of the trunk lid.Hooked up my sub all it does is crackle?
sound deadening. look into RAAMmat.What car stereo products are actually made in the USA??
Dynomat or equivelant really is your only option. The rattles are coming from sheets of metal flexing, hitting one another, etc... and Dynomat or equivelant prevents this (if applied properly).I want to put 7 amps in my truck totaling 6400 watts. Should I get a capacitor and how many farads?
Good Luck!
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.