Question:
I recently just hooked my speakers up and i hear the engine i have a pioneer radio also. what can i do to solve this problem?
Answers:
Is a 500 watt amp good for a car audio system with two tens or is that not very good anymore?
Pioneers are notorious for engine noise. Pioneer didn't do good job grounding the RCA's. Just skip to the picture. Follow the directions and you should be good to go. http://www.caraudio.com/forum/showthread...I need a website that has a wiring diagram for a 2000 pontiac sunfire?
You really don't have to use as much wire as is shown in the picture though... a few strands will do.
Do most new cars these days come with DVD players?
resistors , first try resistor spark plugs that will usually do itI was thinking about buying a decent subwoofer. do u hook sub up to the deck or amplifier?
I think you need a noise supresser????What size amp do you reconmend for two 12" 750watt subwoofers?
If it is "popping" its probably plug noise. as someone mentioned get resistor plugs. also new set of resistor wires (if that type of system). if it is a steady whine that increases with engine speed - it may be tha alternator - need a suppressor - or new alternator there (with new slip rings). you might also try a good heavy ground wire from a solid hood bolt back to a good ground on the body. they don't always ground so well through the hinges. grounding the hood helps drain off some noise sometimes.I have a few old cars that have no radio in them and..?
years ago i had the same problem i bout an inline filter that hocks in your pwer line to deck it worked for me...LetsWhat is a website that I can go to for accessories for my car?
properly ground the headunit, u kno that black lil wire hanging off the back of it. if ur speakers are hooked up to an amp then run the rca's one one side of the car and the power cable on the otherThis, as well as grounding your rca negatives, will fix your problem.
Need amp maybe two want more power help?
Do the Big3 Upgrade (power -charge- wire from alternator to battery, ground from batt. to frame, then ground from frame to engine block) all in 4g or bigger wire.
Check all other connections and make sure you have clean, tight grounds everywhere and rock on!
Good Luck!
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.