Question:
i have a cheap lighning audio amp and its 300 rms 4 ohms bridged so its not that big but i cant get it to work. it always goes into protect mode and when it doesnt it just doesnt play the music
Answers:
it might be that the ground moves around when is in the trunk or wherever is at...also if the amp is not new then that might be ur problem...i have an amp for sale is not old i only used it two weeks...2000 watts...my e-mail rpisena@gmail.com cheap price too
Does anyone know where i can get my speakers hooked up in my car for cheap, in san diego?
i dunno maybe it's afraid you're gonna take it's speakersIs the Power Acoustik FUBR Series 12" Dual-Voice-Coil 4-Ohm Subwoofer a good sub?
your amp can not give alot of power so its turns it self off Get a new better amp.OR make your speakers 8 ohms.What are some good component speakers?
speaker to amp impedance might be too low . try using two 4 ohms speakers, one on each channelHi. What would be the output change from my 4ohm two channel 100 watt rms amp.?
Usually if an amp is going into "protect" mode it's either because the speaker impedance is too low, you're connected to a blown speaker, or your speaker wiring is shorted or mis-wired. Some amplifiers will show a protect light if they have a very poor ground connection. If it goes into protect with a good ground and no speakers connected, there's an internal problem with the amplifier.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.