Question:
I am using 2 Sony Xplode XM-552zR 350w max power output amps.
2 12" 1000W Peak Power Sony Xplode Subs.
1997 cadillac seville radio removal?
Panasonic CQ-C3403W MP3/WMA/CD Player
Putting 2 15" L7in a blazer, with a seal, or ported box?
2 6.5" Panasonic speakers and 2 6x9 Panasonic speakers.
How do i remove speaker cover on ford ka?
ALl new just have no idea how I can make the subs powered by the seperate amps.
How do you remove the rear deck in a 2004 Honda civic sedan?
Have I jumped into the water without knowing whats down therE?
Answers:
I have a 1994 opel omega with 900 watt amp and 2 600 watt subs but my subs don't work?
It sounds like you're trying to run one subwoofer on each amp. If it's not too late, your best option is to return the two amplifiers and pick up a mono amplifier instead, like a Sony XMD400P5. This would be less expensive, simpler to hook up, and provide more power to the subwoofers.To run two subs on two amplifiers, you should pick either your front or rear output as a subwoofer output. Most people use the rear output. You will have to use RCA splitters so that this output can provide the same signal to both amplifiers. Follow the instructions for "bridged" amplifier wiring when connecting the subwoofers to the amps.
How can i have my subs work perfect with a Line Level Converter?
Check and see if your head unit has dual outputs or a subwoofer out on the back. Run one amp off the regular output and the other amp off the subswoofer or other output. Get a crossover, this will allow you to tune your system for optimum sound. Update: Just checked on panasonic website, you should have dual outputs so RCA cable from one to the first amp and ditto to the second one. Advice still stands on the crossover though.Installing aftermarket cd player in altima?
That is no problem. you can use the rear outputs. you will need a few Y-adapters to split the RCA's to the amps. on the amps turn on the LPF or Low Pass Filters to block out the high and mid-range. then all you will need is a dual amp kit. it is made for two amps and will have a distribution block for the power wire. you will have one power wire coming from the battery to the Distribution block. the block will split the power wire into two power wires or the amps. then just proceed as normal.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.