Question:
Kicker Solo-Baric L5 - 12" subwoofer with dual 4-ohm voice coils
Rockford Fosgate Punch P550.2 amplifier
When the voice coils are wired in parallel the woofer presents a 2 ohm load. When the voice coils are wired in series the woofer presents an 8 ohm load. In addition, each coil may be connected to a different amplifier channel and each channel will see a 4 ohm load.
Answers:
How can I set the time in a jvc kd-g110 car radio?
That amplifier is not a good match for a single subwoofer with dual 4-ohm voice coils. However, if I were doing it I'd wire the sub for an 8-ohm load, then bridge the amp to run it. This is the best of a set of bad options.Need a wiring color chart for a 1994 CAMRY?
If you wire one 4-ohm voice coil to each channel, you'll get about the same amount of power as above, but it would be more difficult to wire up and easier to accidentally wire the voice coils out of phase. If you wire the sub for 2 ohms, and bridge the amp, you run the risk of overheating the amplifier and damaging it.
How hard would it be to install a CD deck in a '96 SL2 Saturn?
to get the 550 watts x 1 at 4 ohms.take each sub and wire them in parallel so each sub is at 2 ohms then take the negative of 1 sub to the positive of the other sub and then take the one positive that is not hooked up to the positive side of the amp and the negative thats not hooked up to the negative of the amp.Time to get a matching Subwoofer.wire the voicecoils in series..then wire the remaining connectors parallel..this should show your amplifier a 4 Ohm Load and Increase your SPL.
In this case 8 ohm is the best bet.
Buzz in car stereo when headlights are on?
Running each coil to each channel isn't recommended as the slightest differences in component values of each channel can cause uneven heating of the coil and cause it to warp.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.