How to eliminate factory amp in a 1998 dodge ram 1500 to install aftermarket radio?

Question:


Answers:

What are the speaker wire colors for 2006 cobalt?

The factory amplifiers are attached directly to the speakers, so the easiest way to bypass the amps is simply to replace the speakers. However, it's not really necessary to eliminate the amplifiers in order to install a new head unit. The factory amps will work just fine with the new radio in this vehicle; you just need to be sure to connect the amp turn-on wire in the vehicle radio plug to the remote output on your new radio.

2003 Saturn L200. Where can I find and an Adapter to hook up an amp and sub?

You can get an Amplifier bypass harness when you are going to do the install. Or you can do it the hard way, get a wiring color codes sheet and start snipping...

What are some good speakers that go along with this Deck?


Alot of people, bypass the Factory amp, cause well it doesn't put out as much as the Aftermarket HU would, most new HU got built in amps in em'...SO for instance, my stock amp had 12watts, HAHA ridiculous, my new headunit is 60x4 watts, sounds better with new speakers too, might wanna look into those as well
Good luck with your install
More Questions & Answers ...

  • Does anyone know of any software used for designing subwoofer enclosures?
  • My head unit buzzes!!?
  • Most efficient 100 watts x 4 at 4 ohm am ever.?
  • Different amps mess up system?
  • Amp Wiring?
  • I have two amps, both run 621 watts rms. what two subs would sound best with limited trunk space?
  • 20 - 30mm thick mounting plates/brackets to fit 6" x 9" car speakers?
  • Ne ed to ID the wires of a Sony car stereo CDX-C6850?
  • Got my desired system, will it work?
  • Does anyone own a car stereo with built in memory?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.