Question:
how exactly do you charge a capacitor? ive looked at diagrams and im just not getting it. what is the easiest way?
Answers:
I need an amp!! how powerful does it need to be?
It has to be charged just before you supply power to it.What would I need to push a Kicker CompVX?
It's best to install it as close to the amp as possible. You may need to get addition power and ground wire the same size you have now. Otherwise, cut the ground and power wire leaving enough room to mount it. The overall length of the ground wire should as short as possible (18" or less if possible, not critical).
Car Subwoofer can be configured to 2 channel amplifier for the better output or mono amp?
Remove the fuse at the battery. If you don't have one, you need one that is rated the same as the total fuses that are on the amp. It must be no more than 18" from the battery.
Girl needs guy advice about car stereo!?
Connect the ground from the chassis to the cap then to the amp.
Connect the the power wire (from fuse by the battery) to the cap then to the amp.
Dre, snoop and bone thugs? bass?
To charge the cap, get a 12v light bulb with leads. Temporarily connect the power wire from the battery to one side of the bulb (at the fuse) and connect the other side of the bulb to the wire going to the cap. The bulb will light and over a period of time (10-20 seconds) it will get dimmer. When the bulb goes out, the cap is charged. Basically, your going to put the light bulb where the fuse was.
Now you can re-install the fuse.
Subwoofer Control for PIONEER DEH-P590IB PREMIER?
_______________________
What a good box for 2 12" diamond d9?
IMPORTANT: Make/print a sign/note that states:
"WARNING: This vehicle employs a large electrolytic capacitor for the electrical/audio system. The capacitor holds a charge EVEN when disconnected. When changing the battery, remove this fuse. Take caution and charge the capacitor prior to replacing this fuse. SEVERE INJURY OR DAMAGE MAY RESULT IN FAILURE TO COMPLY!"
How can I get rid of the static when I play my radio in my truck?
Have a big red arrow pointing to the fuse and one of those yellow triangles with the exclamation point in the center. Laminate this sign and place it near the fuse by the battery.
Something like this:
Is there any way to make a car power amplifier work inside?
http://i81.photobucket.com/albums/j230/s...
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.