How do i wire up my subs to my amp?? i have 2 250 watt subs and a boss 1000w 4 ch amp?

Question:
i have a 1000w amp with 4 channels and 2 250 subs in a vented box how do i link it all up i also want 2 add sum tweeters to my system is it best to wire this in to the head unit??

Answers:

Will these stock radios fit into my 03excursion Model #'s ..4C7T-18C815-AA or 2R3T-18C815-BA?

First we need to know what is the watts RMS of amp per channel at what ohms and watts RMS, ohms and number of voice coils of the subs to fully give you a correct answer.

its something used for your subwoofer amp, its a silver box i think, and goes between the battery and amp...?

Anything else will be a guess.

Amp & Enclosure for two 4 Ohm Kicker Comp 10's?

_____________

my truck cd player has a cd that wont come out?

I wasn't able to reply to your E-mail since you don't have a confirmed E-mail account.

Where can I find Factory Radio Schematics?

amp is 250w each channel or 2 at 500w.
the subs are 500w

I jus put in new subs in my car now when I play cds the subs don't work...they work when I play radio... jus n

I'm going to answer this assuming those are the RMS watts of the subs and amp, if it's not, my answer may not be correct. I'm also gathering the subs are 4 ohms....

Can the Solo-x S18X 2 Ohm be connect an amp at 1 Ohm?

It would be better if you had a mono amp that's 1000 watts @ 2 ohms and wire the subs parallel.

why is my cars speakers getting blurry?

A four channel amp isn't really designed to run subs, but rather 4 speakers. However...

How do I fix my car's head unit?

You will need to bridge 2 pairs of channels on that amp and run each sub to each bridged channel and select 4 ohms. Double check the manual to do this as not all amps bridge the same and not amps can be bridged.

do i need any kind of special wires to replace my factory speakers?

You will then need a seperate amp for the tweets you want.

---

Too much power for my subs?

Install the amp first, connect red (positive) to red Battery terminal , connect amp turn on wire to head unit, run pre-outs from head unit to amp (red and white audio cables) (make sure the pre-outs are not run by the engine or anything that distributes noise) Connect Black (ground) wire to somwhere on the body of your car (bolt it on) Switch to 4 ohms and connect speaker wire to the back of the subs. Thats it

---

More Questions & Answers ...

why sum wite boyz alwayz be tryin 2 be ghettow thuggz likes me n' ma doggz?

How good/bad of a job does Best Buy do installing car stereo faceplates?

Stereo Sound?

Sound System for a 2004 Chevy Impala?

How do i hook up a Mmats dhc1400.5 amp?

the pioneer deh p88rs can be setup in standard (classic) mode or can have a 3way setup, what are the benefits?

how much would you pay for this set up?

subwoofer box?

I need the wiring diagram for my 1996 dodge neon radio wires for the cars wire harness.?

Wanna Buy Pair of 12" P1 Subwoofers With Amp NEW!! FAST SHIPMENT?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.