How do I wire my dvc 1 ohms sub to run at 2 ohms off my amp?

Question:
This is my current connection with 1 channel Pioneer amp:

I recently got a CB Radio, but i don't know anything about them... Help?!?!?

Right terminal on sub: + speaker wire to + terminal on amp
Left terminal on sub: - speaker wire to - terminal on amp
Right terminal - to Left terminal + on sub

Whats the best way to hook up two subwoofers with a 800w two channel amp?

Amp is one channel.

Can this amp push these subs?

I want to make sure I'm doing this correctly because for some reason (could be bad equipment), my Hifonics amp won't push my sub, but my Pioneer will.

Can a 4 channel amp be used to connect 1 12 in sub or do i need a new sub?

Also, fuses are NOT blown, amp is NOT in protect, and the blue power light DOES turn on. Bad internals?

1999 Jimmy Stereo?

Thanks to Sparky and anyone else who might answer this.

Answers:

How to set up a 2000 Cadillac Escalade sound system?

Like so http://i81.photobucket.com/albums/j230/s...

What color is the ground wire on a 1999 doge durango or if some one gots the diagram please send thanks?

Each coil is 1 ohm, right?

I have a never used cd/tape/radio from my Jeep, can I hook it up to my old Yamaha home speakers ?

______________

Are there car reverb units for newer autos?

...and WTF is with the first guy, CRACK KILLS!!!!

Car audio setup, how do I set up the two amps?

Obviously you know nothing of car audio. I know this because he stated he had a DVC (dual voice coil) so adding a 1 ohm resistor would not come out to be 2 ohm, but more like 3 if all were wired in series.

What is the best speaker box desing for two 10" subwoofers?

Even if it were a SVC, the resistor would cost more than another subwoofer (which would be the smart thing to do), would reduce the overall performance by half as half of the signal would be lost in the resistor and would get extremely hot from dissipating that much power.

Does anyone know how to preset the radio channels on a ministry of sound car radio?

A "impedance matching block" is a matching transformer. Finding one that could handle the power his amp puts out, would cost over $500, again a sub would be cheaper.

How do I split an output of my car amplifier for a parallel speaker setup?

Never ever suggest a resistor in car audio. If you don't know, don't answer.

Profile Amps??

You will need to put a 1 ohm resistor in series with your speaker so that the amp sees a 2 ohm load.

How loud will 2 10" kicker L7 Get?

Make sure the resistor wattage is sufficient to handle it - it'll probably be a pretty big sucker.

Car stereo plays 4 short time, then starts to cut in and out (crack), makes high-pitched noise, then no sound?

Otherwise you can shell out a few bucks for an impedance matching block.

Why does my car stereo system shut off when listening to music?

get another 1 ohm speaker and hook it in series with the other speaker

More Questions & Answers ...

Can you run or use a linear amplifier on a cb radio if you have your amateur operator. license for ham radio?