Question:
Answers:
How do you remove a 2007 ford focus radio doubble din. it doesent have the 4 holes on the side?
I would suggest running the factory speaker wires through an RCA converter. This will convert your factory speaker wires into RCA cables. Then you can run the RCA cables through a crossover and filter out the high frequencies so just the low bass is going to the subs. Then go from the crossover through a decent amp to get more power. Then from the amp to the subs. This should give yu the best bass sound from a factory head unit.same as a normal speaker. butyou wont get much power at all if any as you dont have an amp etc.
Any one know where can i fine a alto amp transistors (tr-94-p)?
I'd say you should use wires.Preferable insulated.Can any 1 give me a site where i can buy a kenwood 7011 20pin connector 4 the back?
You can wire them to your head unit in place of a speaker, or wire them with your interiors with a passive crossover. DO not wire them to a channel with annother speaker without a crossover or you will damage your head unit. You will probably have very low output unless you are using high efficiency home woofers, or if you add an amplifier. Car subs will not play very loud off HU power.Can my Ford Fiesta's 6000CD CD/Tuner play MP3s?
you need a 4 ch amp with hi level inputsHow do i remove speaker cover on ford ka?
remove wires from rear speakers and connect to amp
from amp reconnect respeakers and subs
you will also probally want to cut out the lows into the factory speakers and the mids and highs to the subs
the first answer is correct. i worked as an installer for many years.
Depending on the output of the subs you may not hear a thing. you need an amp
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.