How to run power cable from battery to AMP in a '95 Camaro?

Question:
i've searched for ovious premade holes and i'm hoping i don't have to run the cable underneath the car or anything like that. just wondering if anyone has a simple answer that i'm missing. thanks

Answers:

Help me Design my Car audio system?

Drill+Firewall=opening
thats what audio installers do if there is no obvious hole
check to see if there is anything you might drill through that is important, and find a place accesible enough to where you are not going to have to remove the dash, its the easiest way!

---

Is a 500 watt amp good for a car audio system with two tens or is that not very good anymore?

under your bonnet,right by the windscreen,or by the pump for your windscreen wipers,there should be a small black rubber which you can remove...you connect a cable to your negative of the battery and you feed the cable through...it should come out inside the car under the passengers dash...you now have your power cable...you just have to run it under the side panels and to the back of your car..make sure that you dont see the cable so you get a neat finish...then once the cables at the back,you hook it up to the amp.

---

More Questions & Answers ...

I have a 95 mitsubishi with front door speakers. how does the speaker covers come off. there are no scrws?

Is amp fried, if board is burnt?

CD player for T-reg Nissan Micra 1.0 Inspiration?

I have a 4ohm dvc sub hookup parrellel and bridged to amp amp is1400 bridged and the sub is2000max/1000rms?

How do i wire my svc subs to be at 2- ohms?

Please help i don't know how to install a car Aerial?

I own a Autotek MX 1500.1 four Audiofonic twelves and my system is currently out of service.?

Volume -vs- Gain ??

Rockford fosgate?

Head Unit unistall?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.