Question:
SUB:
*Impedance: 4ohm
*Max power: 750watts
*RMS power: 150watts
*Voice coil diameter: 2"
*Magnet: 40oz
*Frequency response: 20-100Hz
What is better to run? Sub Question?
6x9s:
2-layer high-temp ASV voice coil
4-ohm impedance
RMS: 300
Answers:
I need help on wiring for 94 Chrysler new yorker?
I would suggest a 4 channel amp which is tri-mode capable, this means you can run one channel to each 6x9 and bridge the final two together to run your sub. I would recommend an amp that runs about 50-75 watts x4 channels rms. Here are some websites that offer great prices on aftermarket car audio which I have used on multiple occasions, sounddomain.com;woofersetc.com... Also remember it is ALWAYS better to have an amp that will overpower your speakers than underpower them. This way you can fully power your speakers without cranking your amp to the max. Good Luck!I'm having problems with my car stereo. Can anyone help?
it depends how much bass you want. if you just want a lil bass you should proobally get a 640watt amp.but i cant help you with what brand. but watch out for all the cheap ones the will just rip you off.are u sure ur 6X9's are 300 rms? what brand is it? anyway... i have more or less the same set-up wid u...i have a pair of pioneer 6X9's 5-way 80RMS n a 12" infinity sub 300 RMS... i have a lanzar amp which powers dem just fine... i bought the amp at etronics.com for only $115 more or less i dont remember...the amp is 2000W max but dnt believe that...its about 75W x 4 @ 4ohms
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.