In Dash Cd Player won't power on.?

Question:
I took my brother's Alpine cd player out of his old Monte Carlo that isn't runinng and installed it in my 84 Caprice Classic with a wiring harness so i didn't have to cut my wires and it won't power on. I Double checked that the wiring is correct and used an electrical tester to verify that it was getting power to the cd player and I also took off the faceplate and it seems to be getting power to the faceplate. Anybody have an idea why it won't turn on and what I can try to get it to turn on?

Lights That Flash With Music?


I heard that some cd players have an anti theft system that fries the cd player when removed but his car battery was dead so I don't see how it could have fried it.

How do I hook up 1 sub dvc to a mono class d amp that has 2 channels?


Any help would be appreciated.

Answers:

Does anybody know what size speakers fit in the front door of a 95 Geo Prizm with out alot of work?

First, pull any on-board fuses (some high-end units have a small fuse at the unit as backup for the preamps.

I need to remove the cassette player in a '94 Lincoln Continental. How do I remove the dash?


With the faceplate off, look for a tiny hole with a reset button in it...about the size of a bic pen point.

where can i get speed pulse info for fitting a nav system to a renault grand espace year 2000 2.2 rt-x dt?


You should have 2 power lines, most likely one yellow (constant) and one red (switched feed), and you need to confirm that both have power.

Where do I connect a USB to a Kenwood KDC-X590 Car Stereo?


The constant line keeps the clock and presets in memory, and is hot at all times...while thefeed (heavier red line) is only on when the key is on, or in the accessory position.

How can I make it so my indash DVD will play DVDs while the car is in drive?


The small light under the faceplate confirms the constant, and you need to check for a feed at the unit's power line by poking a small hole in the insulation AFTER the splice (close to the unit), and pulling the key back to ACCS position.
*patch the small hole with tape when done.

14" speakers?


Also confirm a solid ground (black line), and if you can't confirm it by sight, then place the tester between the yellow (constant) and the black...the tester should show hot (read 12volts) thus confirming both lines.

Is There a car cd player that can use a zune?


Some older units have an internal trip that will disable the power supply if removed, but the reset switch should bring it back...and for the record, this happened before you touched it, when his battery died...has the same effect.

Do I Need An Adapter Or Somthing To Hook A CD Player Up To My Truck(83 Ford F100 Explorer)?


Also, use one confirmed-good speaker to double-check your outputs, especially if you're using old speakers and-or guessing about the connections.

Can someone give me info about car stereos?

Get an expert to do it or the black market
More Questions & Answers ...

  • 2 12in car speakers make a very low high bass pop noise when turning on/off and changing tracks. any ideas ?
  • ive got a '97 izuzu rodeo?
  • How do i wire two 4 ohm subwoofers to a 2 channel amplifer? please help me!?
  • amp problem?? need help!?
  • does your electric guitar have to match with your amp?
  • how do i boost my bass?
  • is the red cable for on a stereo harness?
  • what is the difference between an "ipod ready" head unit and an "ipod adapter ready" head unit?
  • i have apremier deh-6800 that cuts off when the sun is at high voulume. why? i have a treo 15" ssi with a
  • Why did the dash light go out after I installed a car stereo?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.