Question:
I have a 800 watt max mono amp that is 2 ohm stable 400 rms x 1 4ohm but does no give rms for 2ohm load how do i get this the rms for a 2ohm load?
Answers:
Can I use rca cables from a dvd player on my amp?
RMS Power vs. Peak PowerThe amount of continuous power, measured in watts, that an amplifier produces is called RMS power. The higher the RMS figure, the louder and cleaner your music sounds. When choosing an amplifier, the RMS rating is the power rating you should pay most attention to.
Car adapter for iPod - does your Random songs option on your stereo refuse to play certain songs?
Also, keep in mind that some manufacturers calculate the RMS power ratings of their amplifiers at different input voltages. For example, an amplifier rated at 100 watts RMS at 12 volts can produce considerably more power than an amp rated at 100 watts RMS at the more typical 14.4 volts.
I have a pair of Pioneer TS-G650M 3 way and Pioneer TS-G1641R 2 way. Where should i put the 3 ways?
Stereo manufacturers often display peak power ratings on the face of their products. The peak power rating tells you the maximum wattage an amplifier can deliver as a brief burst during a musical peak, like a dramatic drum accent. The RMS figure is more significant.
Does any one have a wiriing radio diagram on 93 ford ranger?
RMS Power at 2 ohms
This spec tells you how much more power your amp delivers when presented with a 2-ohm stereo load. You can achieve a 2-ohm load by using parallel wiring or by using 2-ohm speakers.
What is the difference between SQ and SPL subwoofers?
Theoretically, amp output should exactly double as the impedance drops from the usual 4 ohms to 2 ohms. However, amp makers use different degrees of regulation on power supplies, which can restrict the actual increase in output.
Where is the factory amp on a 2007 Yukon?
Less regulated power supplies come closer to doubling their output into 2-ohm loads. An amp with little regulation can achieve higher wattage into lower impedances. An amp with stiffer regulation maintains rated output from your amp as other electrical accessories demand voltage from the battery.
High output alternator needed?
Usually, you can figure twice the RMS power at half the load. So most likely it's 800 watts RMS @ 2 ohm.What is worse... bad music no bass, good bass, no mids & his?
Just be sure the amp is 2 ohm stable, if it shuts down (protect mode) then it can't handle this load.
Also the sub(s) total watts RMS must be able to handle this power.
Sound System : Pioneer or JVC or Kenwood ?
See my site for more info http://spkrbox1.spaces.live.com...
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.