Blown Kenwood KDC-MP5028 CD Reciever?

I have a Kenwood KDC-MP5028 CD player. I was installing the system and everything was going fine. The wiring harness has the yellow cable missing which I think the the 12v. I attatched a wire and hooked it all up and everything was working fine. When I pushed the unit into the dash the wire cameout and it touched the black ground wire. I heard a pop and noticed that the unit was smoking a little bit. Now my unit will not power back on. The fuse is still good so thats not the problem. The radio fuse is also intact. Does anyone know what the problem is? Is there an internal fuse I dont know about? Your help wil be much appreciated. Im also trying to avoid taking it to a repair shop because I know they are goind to charge me an arm and a leg.

How do i connect 2 amps in my car?


Thanks,

Im planning to upgrade my MMATS setup,what should i change next?


Johnnie

Answers:

IS350 alpine cd player?

I don't know if you have any technical experience but if you do then follow the troubleshooting steps below.
You will need a multimeter or an AVOmeter, a soldering iron/gun.

Amplifier ohms??


I don't know exactly how that system PCB is designed but I do know definitely that power does not go directly to the processor so don't get afraid.
Since it smoked, check for any physically damaged components especially capacitors and transistors that may need replacement(soldering gun will come in handy here). If non has any physical damage then you'll have to use your Ohmmeter to do some testing following the part the voltage should flow through the circuit.

How do you set the clock on a new pioneer super tuner?


I think I have to stop here because without any technical experience, any more info will be useless to you so you may considering buying a new device.

Help with car amp install?

You have blown the processor in the deck. Make a good paper weight now but that about it. Would cost lots to fix it. Sorry to give you the bad news . There is no fuse inside the unit

What's the difference between Pioneer and Pioneer Premier?

If that hot wire hit the ground wire then you sent a charge back intop the ground side of the unit,, that yellow wire is for the memory for when you turn vehicle off and back on the station comes back to where you had it,, I dont think there is any room inside for an internal fuse, if you put your nose real close to the unit and if it smells like burnt electrical then I would toss it, you can get a nice new unit at Wal-mart for about $100 may not be a kenwood and all, but I have a good Pioneer for $88 from Walmart or you can see how much to have it fixed,

How to replace the amplifier in your cars head unit?

well not calling you dumb at all but if you didnt know what that pop meant dont try to fix it and whyd you buy kenwood in the first place(hit myself in the head) um chunk it and buy alpine or something oh and have it professionaly installed if you heard a pop and silence after your last install
More Questions & Answers ...

  • How Much Would 2 Tens cost for my radio system??
  • Need a good amp to match two Type Rs?
  • Gearhead question, Does Dodge put option codes where they can be seen? and where can I find a decipher list?
  • JL Audio W3 question?
  • What is this ?!!?
  • Subowoofer sounds crappy is setup right??
  • Is there already an amplifier bypass inside the 2001 hyundai XG300 when you buy it?
  • Why do I get hollow sounding bass through my car audio woofers?
  • Sub question, if i hook up my vc in parallel to get 1 ohms how does that effect my rms amp watts?
  • 1994 Ford Probe SE head unit wiring?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2009 CarQnA.com All Rights Reserved.