Question:
ok so i have a KENWOOD KAC7202 2-Channel 920W AMPLIFIER 150 watts RMS x 2 at 4 ohms
and i have two kicker comp 12"s that are 150 rms and are 4ohms each how would i wire this
Answers:
Blown Kenwood KDC-MP5028 CD Reciever?
Get a big *** cable or amp connection kit and wire directly off the battery, better get a capacitor too unless you want your headlights to go with the bass. and probably a heavy duty alternator too.Kicker Quality, L7's poor quality?
wire each to its own channel. that gives each 150rms which is exactly what u wantWhat is a quality FM adapter for my car that I can use for sirius/xm as well as mp3 (not an iPOD)?
you failed to mention if the subs were dual coil or not.this would make wiring more complicated.assuming they are not,i would wire it in stereo.most amps will have a stereo/mono switch.by setting to mono, you will get equal output to both subs.turn the gain and bass boost(if any) all the way down to start and gradually move them up until they sound good with no distortion.a good crossover goes a long way.Do Anyone Know where to download car stereo manuals specificly Dual xdmr 7700?
hook each sub up on its own channel if u dont u willl blow them forsureWhat is the diffrence between a 2ch rca cables and 4ch rca cables ...they both look the same ?
wire each sub to each channel, perfect fit, as far as HO alt and cRapacitor, don't bother. 300 watts RMS don't need that crapThe easiest thing to do is to go to a car audio store and buy a kit for about 1000w or maybe a little higher. Always go a little thicker gauge (smaller number) than the amp your powering. It'll give you all the connectors, wires and instructions on how to install it. You may also want to get a new battery lead that has a couple places to hook up wires to make sure everything is connected properly and won't slip off.
It's pretty easy to install it yourself and save $75. Decide where you want everything, mostly your amp. You'll hook up the power cable (long red) from the positive battery lead to the 12+ of the amp, the ground (short) from a bolt that goes into metal to the GRD, and the remote wire to REM (you run this to the back of your stereo, it will turn off your amp when your radio turns off so it doesn't drain your battery or fry the amp). The best input connection is by using RCA cables if your stereo has the connections in the back. Otherwise you can take regular speaker wire and hook it to the wires of one of the speakers in the back then into the amp. Then just run a wire to the subs. Since it's made to power up to 4 speakers, you can bridge two of the outputs, one for each sub. All the wires and cables can be hidden under the running boards at the bottom of the door jam or under the carpet. You also run them through the firewall (separates the engine compartment from the rest of the car) along with wires already run, you just have to find the hole and make sure there's enough room.
I have a subwoofer in my Chevy Malibu and i was wondering....?
Installing it yourself will probably take several hours especially if it's your first time but if you have any more questions refer to this website. It'll tell you everything and more.
What should i use to power my JBL dual 12 inch subs? help please!?
http://www.crutchfield.com/learningcente...
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.