Question:
now i got two 10 " rockford subs and im adding two 12" i know im going to need a new amp but how is it going to work am i going to have run more wires to the battery or can the new amp be hooked up to the one thats there now im confused? and dual voice coil is what ?
Answers:
If they are 4 ohm DVC, wire them like so http://i81.photobucket.com/albums/j230/s... for a 4 ohm load for best performance. Get an amp that's the total watts RMS of the 12's at 4 ohms.
My remote wire to my amp has know where to hook up too anyone know were ?
Be sure the amp you buy is CEA-2006 compliant.
Speakers at 3 ohm resistance, how do I calculate power given by an amp?
If your total system power is 1000 watts RMS or more, you will need to:
How to install my gps to my car speaker?
1. Upgrade the alternator to a high output alternator
2. Upgrade to a heavy duty deep cycle battery
3. Upgrade the "Big 3" - that is to replace the power wire between the battery and alternator and the ground strap.
Anyone know anything about Cadillac CTS Audio systems?
Failure to do this will result in you replacing them anyway as the alternator will eventually fail.
I want to install Dynamat throughout my whole car?
Here is a guide that will calculate what size alternator and power wires you need http://www.datafilehost.com/download.php...
You'll need Microsft Excel to use it.
See my site for more info http://spkrbox1.spaces.live.com...
Powered sub installation question?
You are going to tear up your battery wiring all that stuff too it.Car batteries are not generally made for that.
Don't let that stop you though.
2 Kicker 05C158 15 inch Component Subwoofer, 8 Ohms?
What type of Rockfords and what impedance are your 10's? What amp do you already have? What gauge is your power cable? What kind of battery do you have?I have 2 component speakers, 2 subs, 2 6x9's and 2 4's. i was wondering what amp/amps i should us?
you have a lot going on.first of all make sure that your power wire going to your battery is at least8-gauge, although a 4- gauge would do fine. if not then you will need to run a better wire to your battery. next, for ease of install hopefully all of your subs are either dual voice coils or not. if they are mixed, then you have a situation where you need to be careful or your amp will heat up and cut out on you while they are playing . check with your local install shop to get help with hooking up everything and getting it right. first, get all the model numbers off your subs and amps, as this helps installers know what to do. and as far as dual voice coil speakers, they have two sets of terminals on them.they can be wired in parallel or series depending on how many subs and how low you want to go on impedance(that's the four ohm or eight ohm subs). sounds kinda confusing, but that's the best i can do for now with the info you put out.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.