How do i wire a 12" type r 1241d sub at 4ohms?

Question:
whats the difference between 2 and 4ohms in terms of power and how can i check that my sub is wired at 4 ohms...
thanks

Answers:

Feed form ann amplifier?

See my site for more info http://spkrbox1.spaces.live.com...

---

How good must a car stereo system be to set off car alarms?

The 1241D can't be made to have a 4 ohm load without leaving one of the voice coils disconnected. I don't recommend this because it cuts the power handling of the speaker in half. I also don't think Alpine recommends using only one voice coil of a speaker. If you just HAVE to use this speaker, use only one voice coil and don't connect anything to the second set of terminals.
As far as power vs ohm load goes, that will depend more on which amp you are connecting this speaker to.
To check for sure you are at 4 ohms you'll need a volt, ohm meter.

---

More Questions & Answers ...

A question about a car stereo + car speakers?

How much would building my own house cost if I own the land already?

Sirius satellite ready stereo?

Lanzar opti speakers?

How do i use 2/4ohm dual voice coil subs to run on 2 ohm stable amp?

What do you rate Hifonics amps???

Songs That Bump!?

Why do my cds get hot while playing in my car cd radio player?

Questions on what subs would work with amp, RMS,ohms, and channels?

How can i get more GROUND BASS to my system, u no like shaking peoples houses and wut not?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.