I have a dual voicecoil 4 ohm subwoofer, how do I wire both voice coils?

Question:
Do I wire one voice coild to one channel and the other voice coil to the other channel, or do I wire both voice coils into one channel. The subwoofer takes 325 watts rms max, and my amp puts out 225 watts rms each channel.

Answers:

At low volumes, how do i get nice booming bass?

First off, never wire each coil to each channel. The slightest difference in component values between the channels can cause uneven heating of the coils and cause them to warp.

97 BMW 5 series CD changer question?


Your amp must be 2 ohm stable and the subs need to handles the watts RMS of the amp at the 2 ohm load.

Lookinng to find out which 6.5" speakers are best out these 4 brands...?


Wire it like so http://www.i81.photobucket.com/albums/j2...

Is Lanzar a good amp?


This will give you a 2 ohm load to the amp.

Specs on a 1996 Lexus ES300..?


See my site for more info http://spkrbox1.spaces.live.com...

Ok i would like to know what the deffrence is between 2 way car speakers 3-way-4-way-& 5-way speakers,?

http://www.crutchfield.com/learningcente...

Best car audio?


this link should help

In the philippines what is the best and more affordable car sound setup?

That's BS. You absolutely can wire one coil to each side of the amp. If your amp cannot do 2 ohm mono than this is the best way to wire it. Uneven heating of coils is BS.

2 12" KICKER L7 w/ 1600 rms HIFONICS AMP w/ 4 far. cap will i need alt/batt?


In fact, you can run one coil in a DVC and short the other and it becomes a single 4 ohm sub with 1/2 the power capacity. how's that for uneven heating??

Does Kenwood and MA audio make good amplifiers?


And how about this, when DB drag guys wire 2 amps to the same sub??? (or 4 amps to one sub) I'm sure they don't put out the exact same amount of power, do they, and in most cases, that's thousands of watts, not hundreds. I don't see them warping voice coils either. hmmm...

If i am using 2 amps in my car, can i use seperate amp wiring kits?


Also, I have never seen a warped voice coil. the only deformed voice coils I have ever seen were caused by the voice coil hitting the back plate until it crushed. Oh, and I saw a couple fly out through the cone. Those were pretty messed up when they landed but that was due to defective voice coil glue that eclipse used.
More Questions & Answers ...

  • My new Honda Accord doesnt have an mp3 adaptor place...what should I get that isnt expensive yet works well?
  • Can a sub enclosure be made out of tempered glass 15mm thick? Will the glass affect sound quality?
  • I need a radio installation kit for my 1996 Chevrolet Blazer LS. Please help!?
  • How do i stop buzzing noise coming from my ports?
  • I have two 4ohms speakers and i have a one channel mono block amp how do i wire them to get a 2ohm load?
  • Can't connect Phillips car stereo to my 1990 Toyota Townace. Fuse blows every time...?
  • How do you remove the rear deck in a 2004 Honda civic sedan?
  • Connecting ipod to cd player in car.?
  • Car audio setup, how do I set up the two amps?
  • Does anyone know were you can get codes for your Honda car stero to work,?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.