Question:
i just installed a new head unit and when i turn up the volume to 75% and higher, the mids and highs all crackle and pop. the sub is fine. the mids and highs all run off the head unit. is this a grounding issue? i used 18 gauge wire to ground the head unit, does it need to be heavier gauge? Or is this a problem with my head unit(4 years old)?
Answers:
Channels bridged to a subwoofer?
turn the bloody thing downHow good are your speakers? If the speakers aren't high wattage then they will flutter & vibrate this could be your problem
I want to play my ipod mini in my 2005 Nissan Xterra.?
A larger ground wire wouldn't hurt, but may not help much. You should also make sure your speakers are wired for at least a 4-ohm impedance load; too low an impedance can cause distortion like you're describing. However, you may just be reaching the limits of the head unit's output. Most head units will start to distort as they get close to their maximum volume setting. Turning off bass boost and loudness settings and adjusting the bass control lower should help. If all else fails, it may be time to step up to a separate amplifier for your mids and highs.I have a nissan murano and i need help with the speakers?
Try some bass blockers, worked great for me when I had the same problem. They are really cheap too so even if they don't work, o well there goes $25. Check the link homes.? How to wire a 2 ohm 1440 watt kole amp to a single 1200 watt 4 ohm sub pyle blue wave?
http://www.crutchfield.com/s-tgdtstczvp4...
Sounds to me like you have got no crossover running on the 2-way speakers up front....your head unit will produce all the signlas from what ever music you are playing which is good if you listen yo your music at a low volume...the 2-way speakers are not designed to handle low down bass...crossover will cure this problem so all you have is mid and hi data going to the 2-way speakers....any good car audio shop will sell these...brand names are not all that important so go for the cheap ones as all they do is block certain frequncies not create.
How do you put sound on to immobolisers?
Also Make sure you have got decent 2-way speakers as if they have a low rating that would cause them to distort..alot of head units today will produce 55w x 4 RMS where as standard car speakers from the factory are rated about 25 - 30w RMS
Does a 2006/7 dodge ram 1500 stereo head unit have rca aux inputs on the back of the unit?
Hope that some use to you
I'ed suggest to take off the loud if it's on but the bass will be cut but you want to hear clarity
How do I wire my neon lights to a toggle switch?
if the mids where run on of a amp with a hi FreqQ then you wouldnt have this problem but if they're low on wattage this really aint worth it
Are hifonics amps as good as the rockford fosgates bd series? HifonicsBX1600 V.S. BD1000?
so you should invest in a amp with high frequnency
you could get a wiring kit and (4ch) amp an some up rated speakers for about £60
Will the radio/cd player salvaged from a 01-02 Kia Sportage fit into a 2000 Kia Sportage?
or get a (2ch) amp power distribution block to connect to the power cable for sub's amp and 6"x9" then you wouldnt need to take up the carpet to wire the speaker's for about £60
Car Audio for 2005 Toyota Echo 2DR Hatch?
or could keep th originals play them through and on a high pass this would increase the sound of the mids an tweets
and put 6"x9" in the shelf run off a (4ch) amp
then put the balance to the rear and still utilize the orignals but get more mids and tweets but you would need to take up the carpet to run the wires
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.