Question:
I have Tried putting it in valet mode. I open the switch to on position and press the valet switch for five seconds until the light comes on and then try to start the car and it wont start. Also tried disconnecting all the cables from the module and it wont do anything. Car is cranking all the lights on the dashboard comes on but it wont start. Please help
Answers:
Anyone out there with Alpine CD player with Glidetouch (CDA9855/9853etc)??
In most cases the only vehicle-disabling feature that's used on a car alarm is a starter kill relay. If your car is cranking, that makes it unlikely that the alarm is causing the no-start condition unless some other kind of disable was installed; and even if a fuel-pump kill relay was used, unplugging the alarm module should have taken care of it.You did not say how long the alarm has been on the car. If it is a new addition, it may be the cause. However, the Prestige alarm is made by Audiovox and I know them to be very reliable. I suspect something else, after all it is a '96. After 11 years something is bound to go wrong. I would check the fuel pump relay. I had a '97 Taurus and that went out on mine twice during the 4 years I had it. I had the SVO V-6. Good luck - Gary
prestige alarm system are very good system i don't believe the alarm is the problem charge the battery overnight and try again if you want to disable the kill ignition find the orange cable comming out of the alarm and cut it
Are 5x7 and 6x8 door speakers the same?
to put the alarm on valet mode you turn on the ginition flip or press the switch and turn off the ignition the red led will stay on
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.