Question:
I have a memphis audio amp.. ive seen on the internet in several places its a mono amp.. but the amp has two outputs on it for the subs.. i have two 12's DVC i have them wired to get 2 ohms.. does anyone know how to hook them up to the amp to get all the power from the amp.. i cant find any manuals or anythin on the net or anywhere.if its easier to email me please do so
Answers:
How do I hook up both amplifiers to the same subwoofer?
The terminals are parallel on the inside of your amp. There are 2 + and 2 - but inside the + are connected to each other and the - are connected to each other. They do this for ease of hooking up multiple drivers. Use either + and - and you'll be set to go.Anyone got any leads on a cheap dd?
I don't think you can wire it to 2 ohms.Here's the best you can do
Would a Lanzar 4000 watt amp be good with 2 power acoustik fubr-12 subs?
http://www.crutchfield.com/learningcente...
If you have them hooked on 2 ohm you should have 2 4ohm ohm subs in parallel. Be careful to only run one filter. switch off your radio's(head unit) low pass filter (LPF) and only run you amp's.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.