Question:
I asked this before but I was unsure about the response.
I have a 98 ford ranger single cab?
This is the specs for each of the 2 amps:
New head unit installation in 02 Avelanche?
1200W max power
200W x 2 RMS into 4 ohms
500W x 1 RMS into 4 ohms
Any LOW-COST amplifiers that bump?
The speakers I'll be using is two 400 watt max 200 watt RMs speakers for one amp and two 300 watt max speakers and one 12" Dub sub with the following specs:
Car Stereo AMP & Sub Wolfer Problem, Help?
Size 12"
Magnet Weight 80 oz.
Power Handling 400 RMS
Frequency Response 20Hz - 500Hz
What's the best brand of car audio players??
I have a 4 gauge powere wire from my battery through the front of the car away from the engine heat, through the passanger fender under the tire well through a grommet into the cabin. I had a 100Amp fuse installed 12 inches from the battery. This runs to the back where I added an extra fuse for safety spliced 2 way into two 4 gauge wires. For one wire, it will go through a capacitor to a 40 Amps fuse to one amp where the two 400 peak speakers are connected. I ran out of space so read the next question and reply to that one... please
Answers:
Your wiring is functional. Make sure you upgrade all the wiring to the battery and chassis, and to the alternator. Your car probably has a small ampere output (considering brand), so you may need to upgrade the alternator. When the power supply becomes a question, always upgrade in the following manner;
1. Alternator
2. Battery
3. Capacitor
You could subplant the Capacitor as #1 if you want to do it the cheap and incorrect way. The cap may help "cover-up" your systems shortcommings.
I read some of your other questions and wanted to respond to one thing. You said that you wanted to use a switch to disconnect the power to one amp when not needed. I really wouldn't do it on the main power for the amp, consider putting the switch on the remote trigger from the head unit. The will eliminate the need for a high current switch, the remote trigger is very minimal (12 volts-.2 amp?).
Stuffing in subwoofer box to make it hit harder?
I would also reconsider putting the 2 300 watt speakers on the same amp as the sub. #1, it would reduce the load to the amp to an unacceptable level. #2 you would not have the function of the active low pass crossover for the subwoofer. #3The speakers will not make a "stereo" sound, they would be in mono. And #4, The total power of the amp could be better put to use on the sub, it would make the total system sound more "even".
How do i play videos in my car (panasonic VRX765VD) that i downloaded off the internet,?
Hook up both sets of speakers to the 2 channel amp, that sony can handle a 2 ohm load and you will still have stereo seperation.
What are some good subwoffers?
You have 3 channels of power amplification but 5 speakers? That doesn't sound like an appropriate setup. You can wire speakres in parallel or series to power all 5 with only 3 channels of amplification but you may end up either burning out your amp (if the ohms are lower than your amp is rated) or with insufficient power - i.e. running your amp at 8 ohms will produce much less power than at 4 ohms.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.