Question:
Can I install automatic transmission, if so which one.
Thanks William
Answers:
I have a chevy cavalier please help.?
C4 automatic.Where is the accesory power supply in a 2004 grand am gt1?
Most likely a C-4 ford auto trans and different mounts and drive shaft...So with the fluid in and car is on turn from right to ELF? will the fluid wast out?
borg warner 35Yes, a C4
Out of all the editions, which E36 M3 is the best??
I think any C4 cruiseomatic from a v8 or 250 six will work.1993 Ford F150 Front End Clunk when applying Brakes?
ask the expert's to be sure
How do i install new rear speakers in a 2002 chevy impala ?
http://autos.groups.yahoo.com/group/clas...
In what year did Jeep start putting Fiberglass Hard Tops on the CJ5 and CJ7?
that 3 speed should be a heavyduty syncro like the v8's use
Problems w/humming noise in Honda Odyssey 2007?
C-3 you will need the flex plate torque converter and trans.also may need trans mount and plate. different length drive line.
Toyota Prius Owners: Pros and Cons?
With the price of gasoline these days, I'd install an Automatic OverDrive (AOD) transmission so I could get overdrive and a locking torque converter.How do you pronounce "Vios" as in Toyota Vios?
yes you can and it'll be fairly easy. Any transmission that'll bolt up to a windsor series small block (289,302,or 351)will bolt up to your engine. You will need to change your flywheel, make sure that your new tranny comes with a torque converter, and you will also need to replace your radiator with on that has the ports for automatic transmission cooling lines. Attention to detail. Also you will need to get a tranny that is compatible with floor shifters, or get a conversion kit to make it compatible. The manual is shorter than its automatic counter-part, and a lot shorter than an over-drive auto, so you will need to move your transmission crossmember back a little and may need to drill new holes in the frame for the new cross-member location. Also if you use an O/D transmission you will probably have to get a custom driveshaft made because I think it highly unlikely that you will find one that just accidentally fits, the good news is that any drive-line shop can cut the material out of your existing driveshaft and rebalance it for you. It's a lot eaier to make them shorter than it is to make them longer. DO Not try to run your new automatic without some type of cooling system, either new radiator, or an after-market transmission cooler because the heat build-up will be incredible and will destroy the transmission very rapidly. I hope that this is helpful to you, and I wish you the best of luck with your swap.Jim Falk Lexus .. what was your experience?
They don't have a 250 6 cylinder till 1969(155hp stock). The C4 would work.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.