Question:
Im not rich guy but I need a intake manifold and Im looking at two right now for my ford 302 stock motor exept for headers and higher compression ratio and 600 cfm edelbrock carb. Im looking at the Summit stage 2 intake manifold and the Professional Products the 1500 rpm and up. I cant remember what its called. Anyone buy these? I need a new intake a figure I should get a intake that would give me a little more go please give me your thoughts thanks.
Answers:
what is the value of a 1976 Monte Carlo ?
I would suggest a dual plane manifold with the 600 carb. Something along the lines of a performer. Anything bigger than that or a single plane will just waste gas and wont idle as well.What does the EPC on a VW Passat do?
Yup I agree dual plane. Heres a spankin Edelbrock Performer, new one on Ebay going for near to nothing!What size speakers does a VW GOLF MK4 2002 need?
http://cgi.ebay.com/ebaymotors/edelbrock...
Did anybody see Toyota had ANOTHER huge recall today?
Desk top dyno -tire question on 2005 avalanche?
dual plane - good low end hot shots.
What is the cheapest way to add a horsepower to ur car ?
Single plane - top end , higher rpm's
I Have a 1999 Cadillac Deville and the heater is putting out heat, but not in the right places.?
If your not going wild the dual plane on one with a stock bottom end.
Mk2 Polo electrical fault??HELP!!?
Just depends on what your looking for , along with your gear/tire combo. Biggest bang for the buck , 3 angle the exhaust and port the exhaust , even if you match the gaskets and blend in the ports.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.