How to re-attach sway bar on 91 s10 2-wheel drive.?

Question:
I just bought a 91 s10 and the sway bar or what i believe to be the sway bar is not attached. The bar runs from the a-arm to the other a-arm and right now it is only held in place by a mount on the middle of the bar. I think it needs to be bolted on each end to the a-arms. Is it difficult to re-attach the bar and are any special tools needed?

Answers:

Tightening steering?

Sway bar linkage kits are available at any decent parts store and aren't that expensive. The will have a long bolt, nut, washers and rubber bushings that tie each end of the sway bar to the lower A-frame.

New Car - Audi Q7?

Sometimes they can be a bit stubborn to attach but since both of yours are gone I would hook one side up without tightening it down and then start the other side. Be sure you put a rubber bushing on each side of the a frame and on each side of the sway bar. Better yet find and s10 and take a look to see how they are put together.

What should I do to my SUV first?

Should be able to get sway bar links for it, they're not expensive, you can even check e-bay. They're easy to do, shouldn't need special tools.

Ok, another question about the motor...?

It sounds like you may be missing the end links..

What do you kno about Ford Mustang Diablos?

See "link" below

2001 chevrolet silverado?

http://www.alldatapro.com/alldata/pro~v5...

More Questions & Answers ...

Does anyone own a Mazda protege SE 1993 or know about its performance? i am want to buy one -kenruto@yahoo.com

How many infinity m45's were made in 2003?

I want to swap engine from my base acura rsx to the k20 type-r engine?