Step-by-step guild on installing a bulldog remote starter for a 1997 ford f150?

Question:


Answers:

My 2004 Jetta indicator light came on and i don't have the manual. The symbol is of a car with a screw.?

what model starter, Feel free to email me. I used to install these for a living.All main connections should be soldered.

Dodge Caliber or Volkswagen Rabbit. Why?

F SERIES 1994 -1996
12 VOLT CONSTANT YELLOW (+) IGNITION SWITCH HARNESS
STARTER RED/LIGHT BLUE (+) IGNITION SWITCH HARNESS
IGNITION 1 RED/LIGHT GREEN (+) IGNITION SWITCH HARNESS
IGNITION 2 BLACK/LIGHT GREEN (+) IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 GRAY/YELLOW (+) IGNITION SWITCH HARNESS
PARKING LIGHTS ( + ) BROWN (+) @ HEADLIGHT SWITCH or in DRIVERS KICK PANEL
POWER LOCK PINK/YELLOW (TYPE C) See NOTE *1 IN EITHER KICK PANEL
POWER UNLOCK PINK/LIGHT GREEN (TYPE C) See NOTE *1 IN EITHER KICK PANEL
DOOR TRIGGER BLACK/LIGHT BLUE (+) IN DRIVERS KICK PANEL HORN DARK BLUE (-) @ STEERING COLUMN HARNESS
TACH TAN/YELLOW @ IGNITON COIL
BRAKE LIGHT GREEN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM DARK GREEN/PURPLE (-) IN DRIVERS DOOR HARNESS

Jeep chirping?

NOTE *1 If equipped with FACTORY KEYLESS ENTRY, Vehicle is a TYPE "B" Door Locking System, WITHOUT FACTORY KEYLESS, This is a TYPE C Door Locking System and you MUST get the lock and unlock wires in the PASSENGER KICK PANEL (Parking Brake Braket is in the way) you MUST also TEST for SWITCH and MOTOR wires ONLY with the DRIVERS DOOR SWITCH. On this TYPE C System you MUST TEST from the DRIVERS DOOR Switch only when testing for SWITCH and MOTOR wires.

Bmw 3 series, rumbling noise?

Keep in mind you are going to need a Transponder By Pass module in order to by pass your ignition switch. You will also need a spare key as you need one inside theby pass kit to fool your ohms resitance in your key switch.

What is the range in cold cranking amps (CCA) battery is good for my Dogde 1995 mini van with 3.3 liter engine

It is a very simple hook up you will need to remove the steering wheel shroud, & remove ignition.The easy way to remove ignition is press the silver button on the underside with key in run position, with button pressed a simple tug should do ya.

Have a 1989 VW Passat made in Germany. To register in France I need weights found with chassis number. Help!

Then you want to wrap antenna wire on the plastic housing as close to key switch as possible, then secure with a good zip tie.This can be a trial & error process, You simply have to find the sweet spot, so to say.

Where can I find a 1980-85 Jeep Grand Cherokee Golden Eagle?

Transponder is a simple 3 wire hook up .Power , ground & factory alarm shutdown wire.If vehicle will not start put key in ignition & if it starts then you know it is a transponder by pass problem.DO NOT CUT TRANSPONDER ANTENNA.

Repair Cost estimate on Toyota Tacoma 99 4WD?

keep in mind depending on the unit you install, you may need relays for your door locks to function properly.

---

What is the best car?

I believe there is a good article with step by step instructions on www.fordworld.com . You may have to register to get to the HOW-TO section. But it's not a bad site to visit.

---

More Questions & Answers ...

How roomy is the Toyota 2005 Corolla?

What is the difference between a 2500 and a 2500HD chevy silverado?

My kid has a 1996 chevy lumian 4 door sedan.?

Head gasket?

Buying used Merc or BMW imported from tropical country to be used in cold climate country?

2002 Suburbun suddenly hard to start, nothing, then slowly cranks then starts.?

I'm still driving a Honda Civic 1984 low milage can I go on a trip?

Can you syphine gas from a 2002 monte carlo? I think it happened to me?

Which is a better car? A Dodge Nitro SLT or a Toyota Tacoma X-tra Cab Prerunner V6?

What is that thing?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.