Question:
I have a 2004 Mazda 3 i sedan and when my car shifts from 1st to 2nd gear it shifts hard. It only does this on the shift from 1st to 2nd though. When I accelerate slowly from a stopped position it doesn't seem to shift as hard. And just so that you know, I'm am not accelerating at full speed from a stopped postion to make it shift hard.I had it checked out and they can't find anything wrong. This is my first Mazda car and I was just wondering if maybe this was just something normal.
Answers:
I would have the transmission fluid checked
Okay not sure between the 07 vw jetta or the scion tc. I am 23. Please help me decide...?
Take it to your Mazda dealer, have the Service Manager take the car for a test drive. He/she will tell you what is what with the trannny.does anybody know where I can buy a kit to build a chevy engine from scratch?
Be sure and change transmission fluid and filter every 30,000 miles.What is the name of the woman in the suzuki xl7 commercial who is riding the motorcycle?
Its a problem with the powertrain control module. My grandfather's 95 ford contour does the same thing. The only thing that fixes it is disconnecting the battery and letting it sit for about 15 minues, then reconnecting the battery. Then its fine until the next 250 miles then it starts all over again.Where can i get a under car neon kit for an 06 matrix?
Hi Rachel,how to attach rear license plate to 1989 maxima?
I am in the auto industry and I have many clients asking comparison questions. Unfortunately, the service tech at the dealership may give you bad information, so here is something that works all the time. Go to a dealership, see a salesman and test drive a used 2004 Mazda 3 (not a new one, since the transmission may be different). If it shifts the same, then it probably is inherent in the design. If it shifts smoother, walk to the service department and demand your car to be repaired. Hopefully it is still under warranty, so the cost will be covered by Mazda. Also, don't remove the battery. Your car is designed/programmed different from a 1995 Ford Contour.
on my 1998 dodge Caravan all the LEDs on the environment control module are flashing?
Good luck.
block numbers for a 429 thunder jet?
Greg
where should i look to find a cash car on the web?
I have a coworker with an '05 6S who described the same conditions except that the rough shift was from 2 to 3. After repeatedly taking it back to the dealer, Mazda finally agreed to replace the transmission - under warranty. My coworker described reading about another Mazda owner with the same automatic transmission trouble.how to bleed power steering on a 1989 honda prelude?
Therefore I would strongly advise you to pressure Mazda for an answer. Show them this answer.
How to replace a thermostat on a 1996 Mitsubishi Eclipse. 2.0 ltr, 4 cyl RS model. Thanks.?
The trans fluid should not be changed at 30k, it is supposed to be 100k fluid. check the fluid level(with the car warmed to operating temprature) check 8-24 in your owners manual for procedure to check the fluid, i have a feeling it will be a bit low. yes, i do work for mazda.do i have to remove the engine in a1990 2.9 liter bronco to change the oil pump?
I drive an 05 6i, and I noticed the same exact thing. In between 1st and 2nd it jerks very hard. I have read a lot of people saying the same thing. As long as you have gone and had it checked, you should be fine. I think it may be the way that the car was programmed, and shouldn't be damaging at all. I just hope they get this fixed in the newer models!peugeot 406 instrument panel sticking and engine not starting sometimes?
Take it to the dealer and have them do a quicklearn on the transmission controller to reset the clutch volume indexes (CVI's) this should take care of the hard shift, It resets the way the transmission shifts.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.