Help finding adgustments on a overdrive dodge truck transmision?

Question:


Answers:

will a 2003 jeep rubicon engine fit in 1993 jeep cherokee sport?They have the same 6cyl 4.0 engine?

The kickdown band adjustment is on the outside of the transmission, driver's side about halfway up. It is a squarehead screw with a lock nut. It is hard to get to because of the cooler lines. Loosen the locknut 4 or 5 turns and make sure the adjusting screw turns easily. Tighten the adjusting screw to 72 in. lbs. Screw it out approximately four turns and tighten the locknut to 30 ft. lbs.
The low/reverse band is inside the pan and requires removing the pan and filter. The locknut is hard to get to on it if you don't have the special tools, but the adjustment is the same, except after tightening to 72 in. lbs, back out 2 3/4 turns, tighten the locknut without letting the screw get in tighter.

---

What are the dimensions and weight of the outer part of a Volkswagon van?

i would need to know what engine and transmission it has in it,some of the newer ones are all adjusted from the inside ,not like the older ones was where you could adjust the bands from the out side it helps to add all the info you can when asking a question,,good luck.

---

More Questions & Answers ...

i threw my wedding ring at my hubby dash whered it go? 2006 dodge pu?

Shift Light on nissan sentra spec v?

I have a 1980 plymouth arrow truck, and I need replacement body parts, also known as dodge d50. HELP!!?

difference between a performance module and and a performance chip?

Anyone have or had a mitsu. eclipse?

previa or lucida? and why? thanks?

Could you fit 2 or more rotary engines in a 1991 RX-7?

Service Engine Soon light flashes and then stays on?

What V8 will bolt up to my 4.0 transmission 1987 jeep cherokee?

what can cause a loud sound of breaking on a front end of a car?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.