Question:
i have a 1967 ford mustang 289 4bbl, and am getting ready to have exhaust replaced. Can i get side pipes going down side of car like the old corvettes had? where can i get it from and how much will it cost me??
Answers:
How hard would it be to install a sliding ragtop on my jeep cherokee?
First i gotta ask why? Then Yes you can it may be a custom job. They can run a pretty penny, Try a local exhaust shop.2000 dodge intrepid 2.7 : when i kick car in passing gear the check engine light flashes?
You can go to a workshop and ask them..Or grooming shops or customisation shops 4 example west coast customs in usa..
good luck! what colour is ur ford?
How do i change the rear brakes on a 1996 eagl etalon?
i dont think that would look very good, you could try getting side exhaust were the tips come out just before the back tires, but if you insist on getting it to look like the old corvette's exhaust, im sure any custom exhaust place can do itI can't find any reference to my engine which has a 1850 american tall block modification?
yes you can and dude it would look bad and i dont know where you live but in New Mexico i know a place. My shop will do it for cheap.Check: www.jcwhitney.com They used to sell them. I don't remember how much though. I have seen them on a lot of 70's Trans Am's too.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.