Question:
2000 Mitsubishi Eclispe gt v6...just wondering how much for the parts and labor? links would be nice or your source!
Answers:
How should I Pimp my 2007 Pontiac Vibe?
First off, its going to depend on the labor rate at the shop. What kind of clutch assy they are using. Are they resurfacing the flywheel? Changing the pilot bearing?I work in a transmission shop and I looked up the labor here and you would be looking at $740 in labor ( assuming this is a 3.0 and not a all wheel drive eclipse) with resurfacing the flywheel. I'm guessing the clutch assy would be around 2-300.
See what all is included in the labor, check the warranty and most definitely- have work done at a reputable shop!
call local parts stores. here are a few good ones ive used in the past: auto zone advanced auto pep boys napa etc. just do some comparative shopping and youll get a rough price range for a guide . as far as labor that can be as cheap as 100-300+ depending on how hard a job it is and where you get it done. ive had clutches changed before .ive owned between 100- 200 cars.
Could someone put a 5.7 fuel injection motor in a 1983malibu,and what i need to do?
you can do it yourself for about $100, most of the labor charge is to take the transmission out and put it back in. a new clutch will only cost you about 100-150 bucksCan my 2005 Toyota Prius operate on E85 fuel without damage to the engine?
well, only do it if you have some experiance, its not hard but you will need typical wrenches and a breaker bar to take off the jv joints
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.