Question:
Answers:
Does anyone no how to remove the backseat out of a 06 Toyota Corolla Xrs?
When you open the door... Look for mounts that connect the door to the truck.. Simply unbolt those and you'll be good to go!Do you want to buy my 2000 Chrysler 300m?
Remove the bolts holding the door in place.We are looking at a PT Cruiser 2004 model. Any Owners?
you have to take out the pins as the hinges are made onto the truck body this is a job best done by a body shop as they are pressed in.1. Open door. 2. locate hinges. 3. Un-bolt bottom hinge then top hinges. 4. unclip wires beneath door paneling. 5 door should be on ground at this point if it is not then reffer to section 3. 6. enjoy a snack as you are finished.. you have just removed a door from an 89 s-10.
What do you guys think of the new 2008 avenger?
I DONT KNOW ABOUT SOME OF THESE ANSWERS, THERE'S NO BOLTS IN THE HINGES, YOU HAVE TO KNOCK OUT THE DOOR PINS THAT CONNECT THE HINGES TOGETHER, AND IF THERE IS WIRING, JUST UNHOOK IN THE DOOR AND PULL OUTthe hinges on an S-10 arent bolted in, they're welded. you have to knock the pins out of the hinges. better have help!
How can I fix a high speed vibration on a 91 YJ?
Are you looking to replace the pins and bushings to repair a sagging door? This is a two person job or if you know someone that owns a body shop they might have and let you borrow their stand for doing just this type of job. A couple of tires stacked up with your helper keeping the door from tipping over workd good too. You don't have to disconect the wire harness this way. You are correct that the hinges don't bolt on, they are welded to the door and athe truck a pillar. The pins are not pressed in. With the door open stuff some rags in between the door and fender so they don't hit each other and scratch. I use a long punch and a big hammer. It takes a few good whacks to get them moving but once they move they come right out. The top one if I remeber correctly drives down and the bottom one drives up to remove them. Knock them out pull the door away a bit, then you can replace the bushings. Just make sure you put them back it the same direction they were before. If you don't the hinges won't fit. If I remeber correctly the top and bottom bushings in each hinge are diferent sizes, top is bigger inside diamiter. Install the new bushings, slide the door back in place, install the new pins, and put the retainer clips on the ends of the pins. A socket small enough to cover the clip but go over the pin with a long extension and a small hammer work well for the retainer clips.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.