How to replace a camshaft postion sensor in a 2003 chevy blazer?

Question:

Answers:

Disconnect the spark plug wires and ignition coil wire from the distributor. Refer to Spark Plug Wire Replacement .

Disconnect the camshaft position (CMP) sensor harness connector from the distributor.

Remove the distributor cap screws.

Remove the distributor cap.

Remove the rotor screws.

Remove the rotor.

Align the square slot in the reluctor wheel with the CMP sensor.

Remove the CMP screws.

Remove the CMP sensor.
Installation Procedure
Important: DO NOT use the old cap, CMP sensor, and rotor screws. Use the replacement screws that have been coated with a thread locking compound.

96 Ford Tempo, fuel pump stays on at 38 lbs, whizz in tank continues and car will not start?

Insert the CMP sensor through the reluctor wheel slot.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

I have my PIN for Golf radio but do not know how to activate it.. any ideas?

Install new CMP mounting screws.
Tighten

Anyone SELLING an AUTOMATIC Nissan 240SX or Honda CRX?

Tighten the bolts to 2.2 N·m (19 lb in).

New 2005 Ford Expedition, auto door lock no longer working?

Install the rotor onto the reluctor wheel.

Install new rotor screws.
Tighten

Where is the automatic transmission dip stick located on a 1999 Isuzu trooper?

Tighten the screws to 2 N·m (18 lb in).

The rear windshield wiper on my 2001 Jeep Cherokee is dead. Any ideas on how to fix it?

Install the distributor cap.

Install new distributor cap screws.
Tighten

Can anyone tell me if it is possible...?

Tighten the screws to 2.4 N·m (21 lb in).