Just installed new ac compressor on bronco, was told need to reset system for clutch to engage. How?

Question:
1995 Ford Bronco.

Answers:

Sorta car question?

If the freon pressure is low, a safety switch disables the compressor. It will be on the passenger side near the drier, near the firewall. Unplug the two pin connector & insert a jumper wire. This will allow the compressor to run while you charge the system with freon.

How do you reset the check engine light on a dodge ram cummings desil quad cab truck after an oil change?

There is nothing to reset.

Where can I buy a new seat for my 79 Ford pickup?

If you installed a new compressor you must have emptied the system of refrigirant.The system now has to be vacummed and refilled with refrigirant.Make shure you put a least a cuople of onces of refrigirant oil in the compressor or it will seize up THEY CALL THIS RECHARGE
More Questions & Answers ...

  • Why is Chevy trying to cash-in with the success of Toyota Scions xB, xA and TC by creating this compact cars?
  • Problem with bmw ignition will not start engine but everything else turns on HELP?
  • Tune up question?
  • Im looking for a used bmw?
  • Is the 4L60E tranny stronger in different GM vehicles?
  • Posted ? 01 jgc v8 ystrday Engine loud told need oil pump replaced is this expensive?
  • How hard is it to put a transmission in a 86 honda prelude?
  • Hey yall got a 82 trans an i need parts?
  • VOLKSWAGAN PASSAT... ALARM WENT OFF, ever since...?
  • Jeep dana30 and 35 question.?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.