Question:
I have a 1997 jeep wrangler. I purchased a hardtop that needs windows installed in it. I have purchased used windows. How do you install the windows in this hardtop?
Answers:
My 95 Lexus started to lose power and make noise oil light check engine light came on no smoke?
Short answer: I recommend taking it to an auto glass shop or a Jeep dealership. If you have the glass already, the installation should be fairly inexpensive.Saab Clarion radio/cassette and equalizer problem.?
The procedure is covered in detail in the factory service manual (a very good investment for any do-it-yourself Jeep owner, and not too expensive on ebay). Glass installation is not trivial. I'll try to condense the instructions here:
What is the difference between a 4.6 liter police interceptor and a 4.6 liter mustang engine ?
1. Trim the urethane from the opening, leaving a 3mm level base. Place glass in the opening and make sure it fits and seats against the level urethane. Make alignment marks with a grease pencil
I'm driving the Opel van (looks like one)?
2. Remove the glass to a workbench, lay flat, inside-up.
How would you rig up a cooling system on a 1998 Sunfire so it runs pressure free?
3. Clean the glass with ammonia-based glass cleaner, then clean outer edge of glass with naphtha
1999 dodge caravan trans probs?
4. Apply molding to perimeter of glass with butt-weld in the molding at the bottom center of the glass.
5. Apply "glass prep" adhesion promotor 1" wide around perimeter of glass, wipe with lint-free cloth until no streaks.
What sensors effect the timing on a Ford Focus?
6. Apply "glass primer" 1" wide around perimeter of glass. Allow 3 minutes or more drying time
How much mileage can a Honda go up to?
7. Apply "pinchweld" primer 3/4" wide around the quarter glass fence (on the hard top). Allow 3 minutes or more drying time
1994 ford escort how to you add transmission fluid on a manual?
8. Apply a 0.4" diameter bead of urethane to the center of the quarter glass fence surface area. (I quoted this instruction directly). Go to step 9 immediately - you only 10-15 minutes before the urethane starts to cure.
Ford 460 exhaust manifold bolts?
9. Align the glass with the grease pencil marks and push inward "until the reveal molding is seated on the hardtop." Don't push so hard that too much adhesive squeezes out.
What do u think of the ford focus?
10. Open windows and liftgate while urethane cures to avoid pressure buildup. Apply 2" masking tape strips every 10". After urethane cures, remove tape strips and water-test.
Jeep Grand Cherokee Laredo 2000?
Damn, after i read this guys answer I pretty much am speechless!More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.