Question:
Washer pump motor is not working, verified the lines are not clogged, tested the motor by unplugging wire going to washer motor and hooked it up directly to jumper wires...motor is dead.
Answers:
See if you can buy one at the dealer or at auto zone and put it in your self.it`s easy. Dealer will charge you about $65.00+part cost. Its a 15 minute job and i`m slow.
Expect to pay between 100.00 and 120.00
can any one tell me where i can get a diagram of a k reg peugeot 106 fuse box?
go to a wrecher spend 5 bucks get the part put in on urself totol 5 bucks and 1 hr free labor and a few bucks for gas to get to and from wrecher good luckWhat voice commands are there for a 2004 Acura TL w/o Navi?
go to auto zone,purchase a w/w pump, mount it near water reservor, wire it into existing pump wiring, total cost approx.$ 25.00will 4.5 interchange with 4.9 in 93 deville?
carquest ,napa, advance auto parts,o'reillys no more than $25.00 you dont want to go to the junkyard for that kind of part . buy new.i want to buy a willie ww2 jeep new one?
I would suspect around a hundred bucks. These are pretty simple to replace. Why didn't you replace it if you have already checked the lines and the electrical connections to it? The pump just sticks into the washer jug through a rubber grommet and snaps into the jug when fully installed. Try it and good luck.engine oil grade and capacity for a 2.0ltr ford galaxy?
bring it to me and i will do it for 10 bucks. you supply the part and i will supply the labor. have you done and outta here in about 10-15 min.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.