Rebuilt,GM 350 ,5.7,need aparts list for new sensors can anyone help?

Question:
I found the knock sensor,but not sure what else to replace am moveing parts from old engine to rebuilt,this is my first try with help,this is a92 C1500 in good shape!

Answers:

A knocking in the engine when car is idle?

the question is, is did the engine run ok other than like a knock or locked up b4 this project was started if you are rebuilding due to milage oil consumption or the eng locked up i would use old sensors over

---

Want a Mercedes?

sensors go bad , so be careful when switching parts over. also make sure the parts you're putting on are compatible, especially sensors , check connector pins on sensors and harness. tip: take old ¤t parts you're gonna use and put them side by side,look @ them . it should be readily evident if you can use it or not.. if this is your first time make this a good learning experience, take your time .somethings you may not want to use off old motor.

---

More Questions & Answers ...

What do u think of toyota celica?

Oil pump for 01 ford f350 7.3 liter?

Is a 1992 Lincoln TownCar a good and reliable car? Any known problems?

What does it mean when the gas light blinks on a mercedes clk 320?

What year is B regerstration for cars?

What other rear end disk conversion can fit the ae86?

Does anyone know where I can find a Silvia S15 Widebody Conversion for a '96 240sx?

How do I change ford drum brake shoes[2002,e-150]?

Where can i buy a second hand corolla?

I am looking for a 1998 GMC Safari power door switch for the left door. I can't get one anywhere. Please help

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.