Oil leaking from around drain plug- 2001 jetta?

Question:
just had the oil replaced at Firestones and have noticed a puddle of oil under car whenever I leave it for long periods of time. Checked under the car and I can feel oil under the oil pan coming from around the drain plug. also there is small amount of oil on near the oil filter housing

Answers:

2005-2007Jeep grand cherokee question...?

Take it back to them with your bill. Let them tighten it up or replace the washer on the drain plug before they tighten it. Complain on a sloppy job.

Honda engines?

it could be residule oil left that wasnt cleaned up properly if not the drain plug could have been over tightend or the crush washer not replaced with a new one like it should have been

What are Ford FE Heads, Casting # C5AE-F.?

Try tightening the plug on the oil pan. If that doesnt work, get a washer to fit on the plug bolt. Costs about a quarter.

Dasshboard button?


Oil on the oil filter housing may be from the oil change. If its fresh, then the filter needs to be tightented by hand.

Does anyone own or remember the GM cyclone p.u.? , it would break the tires "loose" at 50mph !?


Dont go back to firestone.

Gas mileage on 01 grand am gt?

The next time you have the oil changed have them replace the washer and torque the plug properly. The oil filter can be tightened slightly.

Does anyone know how to replace the brakes on a GMC Sierra?

VW's have a aluminium oil pan. most quick lube places tend to over torque (tighten) drain plugs and strip the threads. thats the worst case scenario. if you're lucky it was just left loose.
the oil filter housing is accually an oil cooler. and coolant runs through it to cool the oil. its posible that the seal is leaking and thats why you see the oil or they just did a messy job of changing your filter. and didnt clean it up afterwards. hope this helps you out some, good luck.

Does ne body kno how much would it cost me to change my 96' golf GL to an automatic?

Not put back on right! SOMEONE didnt clean up around the pplug area, so you got all that gunk and crap settling at the bottom by the drain, and just interfered with the tight fit...

I have a 2005 chevy cobalt and when i stop the rpms drop to 500 and back to 1000 yet they say it is fine?


Or not tight enough, the person who did this was obviously a retard and should never be allowed to work on a car again!
More Questions & Answers ...

  • Find caravan show rooms in pontiefract?
  • What is the load weight on the toe package of an 07 Toyota Tundra?
  • I have a 2004 mitsubishi lancer ralliart should i get a magnaflow or flowmaster?
  • Can someone give me a source of information regarding the '87 Mustang LX that I previously asked about?
  • Which emblem am I missing on my 1996 Jeep Cherokee Sport?
  • Toyota Prius Owners: Pros and Cons?
  • What are the differences between the '05 and '06 GTO?
  • What mods can I put on a WJ Jeep Grand Cherokee inline 6?
  • Indicators for escort? and screen washer front and back?
  • When will the 2008 chevy suburbans be available?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.