Question:
Hello i own a 1981 datsun bluebird and it has a 1.8 inline-4 yet i want more power with out a turbo and was thinking could i fit an RB20 or RB30 or 300zx V6 in the enigne bay, if so which of the following could fit, how much work would i have to do & how much would it cost? thx
Answers:
Check the Datsuns forum at www.NICOclub.com, there are several Datto owners with engine swaps there...
2 W D 1997 k10 p.u. where is the external fuel filter located.?
Skip the VG30 from the 300ZX and the RB-series engines.
How do I get the plastic engine cover off of an 06 GTI MK V ?
As with most engine swaps, you have to take into consideration that you will undoubtedly have to do some fabricating in order to make the new engine fit. Then you will have to totally rewire the car with the new engine's computer, and harness. You will have to reroute fuel, water, trans, and other lines that may not go back to their original places once the new engine is installed. You may have to beef up the rear differential to be able to put up with the extra horsepower you are demanding that it accept. You will have to install stiffer springs to compensate for the weight difference of the new engine. You may have to relocate the steering rack...I could go on for a while about the possibles, but I think you have the jist of it from there. Whatever you decide, have fun with it, and keep the rubber side down!
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.