Question:
honda accord 2.0l es 4dr 1999 t reg (uk)
What is the best year for an old Bronco between a 1965-1976?
knocking noise when car starts up from cold then when warms up, it can not be heard much any suggestions?
i think its the crank bearings
engine done 122,000 miles
Answers:
Is there an sr20det engine in automatic?
Unless the car has been abused it shouldn't be the bearings1991 honda civic-Check engine light is on-how do i check it?
I assume you've already checked the oil level and checked for oil leaks. If it is a bearing it won't get better with temperature
Need engine for Suzuki Grnad Vitar 2001, is there one out there? 716-282-8946?
I would suggest you open the hood before starting the car when its cold, then start the car and listen for where the noise is coming from. Is the noise more up front than in the center of the car? Is the noise louder at the top than the bottom? is the noise on the right side, left side or center?
Jeep Wrangler Steering Alingnment?
If you belive it to be a bearing, you can usually short out the cylinder to isolate the noise. If you start the engine and have the noise, remove the spark plug lead from the #1 cylinder and listen for the noise to greatly diminish or go away. If it doesn't, put the plug wire on and try cylinder #2, then 3 and 4. If the noise doesn't go away or get noicably lower in volume, the problem is not with a bearing.
It is not unusual for the heat shields for the catalytic converter on these cars to break welds and knock when cold. It is also not unusual for the inside honeycomb of the catalytic converter to break apart and knock inside the converter housing. If I had to guess without hearing the noise, I'd bet more on the converter or the heat shield than I would an engine bearing.
hope that helps
F150, 98, brake pedal won't return all the way. Brakes won't release.?
What are the best plugs for a 2002 WRX?
.
I am looking for a custom grill for my 2003 dodge stratus .Can you find me one?
you need to start putting in the next higher octane rating gas in the car. i would try that first to see the knocking stops.for example if you now put 87 octane, try putting 89.
My VR6 Jetta will not start, can anyone help?
Your oil pressure level sounds low. Check your oil and add if necessary. If it isn't an oil pressure problem it could be your bearings.Does anyone ever measure the size of your steering wheel?
Balls, a bearing will get louder as the engine heats up, you wouldn't get 100 kms before the bearing ceased up.sounds like a sticky lifter or gudgeon, use only manufacturers recommended oil and it will probably improve the problem.
I have a cheverlet suburban and need to know the year model. the letter in the vin # is Y.?
too many people throw in cheap oil, not realising that this can lead to problems.
do it the old fashion way get a long *** metal extension and touch one end to the other of the engine and you'll point out where the knocking is coming from;even find what cylinder it is (always works)
When the car is cold all the oil is drained to the sump. When u start up the oil takes time to completely lubricate all the moving parts. If you use poor quality oil this is more pronounced. Try and use a high quality oil. It will reduce the knocking noise but not eliminate it completely.
Do you or anyone you know have problems with their 2004 Chev. Suburban?
its piston slap..honda says its normal no worries mine does it toMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.