Question:
Hi,
My Instrument Cluster was not working so I asked various sources for any information and it was suggested to spray the contact cleaner on both the male and female parts of the connection.
As suggested, I sprayed the contact cleaner on both the parts of the connection and it worked. But then again after sometime, when I started my car, nothing came up.
Then I again did the whole procedure once more. It worked once again, and then I started the ignition and left that for 3-4 mins. the display was working, all the gauges showing the activity. But as soon as I switched off the ignition, everything remained as it is, that is, nothing went off except the RPM gauge. So I had to remove the Fuse No. 20 from the fuse box to make that off.
Now nothing is working..:(
Whats the different between toyota camry 2007 gl and glx and se models?
What could be the possible reasons?
Where can i get a rebuilt transmissiion for a 1967 ford mustang coupe 2 door?
Any inputs would be of great help.
Answers:
1999 Grand Am GT Window problems.?
Im going to take a swing and say you have an e34 or e36.heres what you need to do...
http://www.bmwe34.net/e34main/maintenanc...
Sounds like a bad connection in the plug. Try to mechanically clean the contacts scrape the sides with a small screw driver or even a pencil eraser will do the trick. Good luck.
I have a 1992 mercedes what is the oil for this,have 168,000 miles on it.?
It sounds like you have a bad solder connection on the plug that is soldered to the cluster. If you know how to use a soldering iron, just heat up each terminal of the plug on the circuit board and that should do the trick. Good luck.Help! 1987 chevy suburban 1/2 ton not charging battery. New alternator, Battery, checked grounds.?
shop for a new cluster. first check pins on plug for recess.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.