How do I get the factory keyless remote to work on my 1996 Dodge Ram 1500 Ext. Cab Sport?

Question:
I have a factory remote/key fob. The instructions I have tell me to jumper two wires found "under the dash near the floor" inside a capped two-way connector body. Where is that connector body?

Answers:

jaguar x-type mileage?

it needs too be dun by the dealer

Does the toyota tundra come as a long box as well as short?

I'm assuming that this "connector body" is the OBD-II Port. This is almost always under the dash below the steering wheel.

What is the good tire for 2003 Toyota corolla?

I'm assuming that this is not the remote that came with your individual truck. Therefore, you need to go to a dodge dealer and have it programmed. It's a proprietary process, and not available to most shops or the general public.
More Questions & Answers ...

  • Can someone please tell me if the parts on a 1987 Chevy Blazer can interchange with a 1996 Chevy Blazer?
  • How do I remove the FM antenna from my '05 mazda 6?
  • What is an AUDI?
  • how much is the new jag XF going to be?
  • mopar electronic ignition how to wire 5 pin plug??
  • toyota camry vaccume leak?? idle problem?
  • I need to see the diagram for a frieghtliner 8 speed the shif pattern?
  • What do you think about the TOYOTA YARIS?
  • any idea what fuse it is in a ford focus v reg for the cigarette lighter?
  • How long (years/miles) does a timing belt for a 3.0 Dodge V6 last? At what point (years/miles) should it be re
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.