Question:
Answers:
Programming a keyless remote for a ford?
There are liquid head gasket products now sold on the net that can repair the head gasket some claim they last for 15,000 miles and more for and old car like that I would definately go liquid head gasket repair because engine is toast with out it or a new gasket.What percentage of Mitsubishi is owned by Chrysler now?
I think the product is called www.Thermalweld.com
How much mileage do you think I'll get out of a 2003 cavalier?
www.Steelseal.com www.Thermalguard.com
Where is the hood release on a 2007 ford f250 super duty?
On the site www.Thermalguard.com they sell another liquid product that can tell exactly which spark plug the hole in the gasket is blown I think it cost $49.95 the only other way you could tell you'd need a hand held laser light that reads the temp on your engine an rad. But the laser will be pricey.
Where Can I Find a Chevy Cobalt User Manual?
Plus I would almost bet that your fan/coolant sensor unit isn't reading properly a lot of the times that's what causes the head gaskets to blow out. If your TEMP gauge says Ok doesn't mean that it is, most likely is NOT.
How much will it cost to change the color of my 2007 scion tc?
These sensors are not too pricey and not too difficult to replace you could borrow a Haynes manual or Chiltons manual at a library and read up and how to repair it.
Which car is better, a Lincohln Navigator or a HUMMER H2?
If you do go Liquid headgasket repair be sure to clean the rad and engine out with a hose remove the thermostat and replace just the housing for the cleaning process then follow directions on the Liquid.
I saw one guy who had his car done with Thermalweld and he just removed the top rad hose took the rad cap off and shoved the water running hose end in the top of the rad turned on the car and let it clean out for 15minutes.
Importing diesel range rover to California?
Be sure to change your engine oil at least 2 times including a filter to get all the water out of your engine.
You may want to use a Synthetic oil when the job is done this will keep the motor running considerably cooler.
Who makes the OEM (motorcraft) Ford diesel injectors for the 7.3L IDI N/A?
If your lucky the car should last another year or longer.
I own a 1994 Chevy Cavalier. Is there any intake systems available for my car?
Hope this helps you out
How many does the 2005 Ford Freestar seat?
Hola, senor . . . Junipero think is better lift radiator cap and slide new car underneath . . .a 93 chevy cavalier isn't worth putting gas in. So, no it isnt worth it
I have a '99 VW Passat. What maintenance should i have done on it?
only if you are doing the work yourself. It will cost you probably over a grand to have it done, but if you do it yourself it will only be about $100. So much labor involved for a car that is only worth about 500.Get some estimates. You have to figure if its better for you to replace it or get a new car. for the most part a financed car will require full coverage insurance and your taxes will be more. You really shouldn't buy an old car for cheap you will be in the same boat in a year or two. weigh your options, a cavalier may not be the best car, but its better that having a car you can't afford or no car at all.
Where the hell is the master cylinder on a 1980 vw vanagon?
only if you do it yourself..most shops charge 600 to 1000 dollars..PDF user manual for Toyota Yaris?
If the head gasket is the only prob then yes, but the odds are that it has more problems than just the gasket, a new one would cost in the neighborhood of $30-$60 but installing it would be pricey, you'll most likely find that it has more problems than just a blown gasket and it will cost more than the car is worth to fix all the problems, but if you are sure that the only prob is a blown gasket than replace it for sure!My peugeot 306 makes a knocking noise when turning what could this be?
The car is getting into the age that it is going to start nickel and dimming you! Head gasket now then a ball joint then a computer problem.etc,etc,etc....I say fix the head gasket and sell the car as fast as you can! Or trade it in see what they`ll give for it towards something newer!
How do you fold back a soft top on a jeep?
only if the head isnt warped,,,send head to machine shop before you buy the gaskets,,,that 2.2 was known to warp head,and isnt a cheap replacement,if you get a junkyard head,,,will be a good idea to be sure isnt a warped piece ,and use the GM gaskets for the ease of reassemblyBest side steps for a Nissan Pathfinder?
depends how much u like the car how much u want spend on the car is the head warped or cracked head set will run 60 to 100 dollars antifreeze 8 to 10 dollars if warped 30 to 50 to mill head i always replace plugs, oil change how good shape is rest of car if it has lots of other problems i would say its not worth it average price for a shop will run 600 to 1000 dollarsIs it safe to use an K&n airfilter (part number 33-2231) for a 2003 BMW 3251?
If you really like the car and cant live without it....YesMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.