Question:
I have a remote for a 2003 Pontiac Montana that needs to be programmed. Does anyone out there know how to do this?
Answers:
How much should it cost to fix heater in 93 Jeep Wrangler?
Transmitter ProgrammingHeater core on 1999 4x4 blazer, cost to replace?
Important: All transmitters which are to be recognized by the remote control door lock transmitter (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to four transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
1. Remove the ignition key from the ignition lock cylinder.
steering wheel shimmys at all speeds?
2. Remove the BCM PRGRM fuse from the fuse block. Refer to Electrical Center Identification Views in Wiring Systems.
Is a 2006 chevy monte carlo LTZ faster then an 2000-2005 monte carlo SS?
3. Close all of the doors.
i want to ask something about maruti udyog ltd?
4. Insert the ignition key into the ignition lock cylinder.
how can i get free copy of Nissan Tiida(2004/11) Car Owners manual?
5. Within 1 second, perform the following actions: Turn the key to ACC, then to OFF, then to ACC.
Can I erase the adaptation values on my Mercedes PCM?
6. If you only do the 1st step, then the BCM will give feedback indicating the actions so far are incorrect. To program the transmitter, you must do step 5 instead. If step 5 is done correctly, then the BCM may flash trouble codes. In this case, you would refer to Diagnostic System Check - Body Control System in Body Control System.
tell me about the 1970 chevy with air bag?
7. Open and then close any vehicle door. The BCM will chime in order to confirm that the programming mode has been entered.
8. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for approximately 14 seconds.
Important: After approximately 3-5 seconds the BCM will chime once to confirm that the programming has been completed for that transmitter.
Has anyone ever replaced the hood hinges on a 2005 Jeep Wrangler TJ?
9. Repeat the previous step in order to program each additional transmitter.
Is 130K miles too much for a 1992 BMW 325iS?
10. Remove the ignition key from the ignition lock cylinder.
Is it ok to use forever black on the side fenders on a jeep wrangler if they are grey?
11. Install the BCM PRGRM fuse into the fuse block.
Does anybody know where I can find a '67 Mustang?
12. Operate the functions of each transmitter in order to verify correct system operation.
What octane should I use in my 2000 Honda Accord?
(If you need more information, 1-800-492-9568. Ask for Junior in Parts.)
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.