Is it hard to switch an automatic over to manual?

Question:
1997 cavalier Z24

Answers:

What year did the Ford Mustang have ROUND circular tail lights?

On an older, carbureted, NON-electronically controlled engine management system, rear wheel drive vehicle, NO, it's not that hard. On a modern vehicle, such as the one you inquire about, YES. You would have to change over a lot of parts, which include: pedal and bracketry, PCM, some wiring harness, the transaxle itself, the shifter mechanism, engine & transmission mounts, axle shafts (automatic and manual are different lengths on GM products), maybe even some of the exhaust system (depending on model). By the time all is said and done, it probably would be far less expensive just to buy a 1997 Cavalier Z24 equipped with a manual, since those cars depreciate quickly.

I cant find the paint code on my s 40 volvo ?

depends on how hard you think changing a transmission is,cause thats what u have too do

N Reg Fiesta immobiliser?

on a J- body... you need alot more than just the trans to do it..clutch pedal assem. center console for the shifter..and all related parts. not saying it cant be done but how many weeks do you want to spend putting a stick in a 1500 dollar car?

2003 Lincoln Navigator - Whenever my fog lights are on, my fog lights get very very HOT like they are burning?

Depends on who does it and how much you want to spend on this venture. You could put a jet engine into your Z24 if you want.

Where can I Go Online to Customize my Jeep Grand Cherokee?

I did this once (with another car) when I was a kid, decided that I would not do it again.

I' m gonna purchase a 4 door toyota tacoma this summer. Is this truck reliable?

If the mounts match up then all you have to do is your pedals, shifter, shift linkage, pilot bearing, flywheel, neutral safety switch, reverse lights. I think that's about it.

How to change the intake manifold gasket on 2000 chevy venture?

Good Luck

Who has a 2002 Mercedes S-Class?

it is not bout hard, but the parts.. you sure gonna change the gear box, put a pedal (manual brake pedal and auto's are diff) seting up the clutch hydraulic pump assembly, a gear lever,wiring up your computer box..(if apply) well.. if you got all the stuff/parts the work is sure is a piece of cheese cake,.
(experienced mech only)

Two questions about my 1993 Jeep Grand Cherokee.?

you will need many part,s....bell housing,flywheel,clutch plate,pressure plate,throwout bearing,clutch release fork,clutch control mechanism..[ manual / hydraulic ] ,clutch pedal assmy.,brake pedal [ smaller than the one used with an automatic transmission ], a manual transmission,gear shift control linkage, adaptable drive shaft, or manual trans. axle, speedometer cable,....beside,s the knowledge to do this I think that about cover,s it.....your decision.good luck!....also you will need any /all mount,s.

How do you stop squeeking belts on a 98 mitsubishi mirage?

easy

Location of fuel filter on 1998 Malibu LS?

Not if you have a lot of tools, ability, parts and $$$$$$

What to do if i have master key for hyundai coupe but not passcode?

that's a pain in the ***

How do I replace the grill on a 2005 dodge magnum?

You have to change the transmission

Where is the flasher in a 91 chev. cavalier?

Too much work, just buy another car

More Questions & Answers ...

Will Range Rover Sport come out with a hybrid model?