Question:
It's not the brakes, they work fine. Noise is heard only when driving. It sounds like a quiet cement mixer, somewhere towards the right side. I have a 1.0 petrol motor.
Answers:
Mazda MX3 Precidia engine sound high in cabin. Any suggestions to make cabin quiet ? Thanks?
You didn't say the year of your Peugeot 205... but since I have owned several, I'll tell you what to look for.1983 to 1998: These wheel bearings are VERY READY by now to be worn out! The test for this is to put on some garden gloves. Grab the right-hand wheel firmly and try to SHAKE IT hard. Do you feel any play, any click, anything less-than-solid? Do you see any uneven wear on that tire?
Does anyone have a mirror for my Lexus truck? I can't find it anywhere. New? Really expensive.?
Yes? This is a replacement job for an experienced DIY person. Replace ONLY the one wheel bearing, because you may not have this old car forever. You can purchase SKU bearing # VKBA882. This fits left or right 205.. '83-'97 costs about 45 euro. (dont pay full price for Peugeot parts!) You'll need a repair shop to "press" the old one "out", and the new one "in".
How much will a second hand maruti gypsy or mahindra jeep cost in delhi?
1983 - 87: Drive shaft noise. Do you also hear "clunk clunk clunk" when you turn a sharp corner to the right? This is a bad drive shaft END. And it isn't worth fixing. Get a used replacement. Scrapyard. 40 euro or so. If you don't hear the clunk.. ignore this advice.
How do i use the steptronic feature on a bmw?
1987 - 98: TU-9 engine one litre. Right hand drive shaft ONLY. This is a different engine, with a right hand drive shaft that is VERY long, and it has another bearing in the middle, to help it bend 30 degrees. AND THIS BEARING IS THE NOISE YOU HEAR!!
This bearing DOES wear out faster than the wheel bearings. Around 150,000 km = 100k miles.
This drive shaft is difficult to remove as you are lying on the ground. There are hidden bolts to remove it. You need a hammer and a bad attitude. And it costs 200 euro, new! 100 used, if you can find one, because EVERYBODY needs one after 100k miles.
I have changed two in my life. It's two afternoon's work, in and out. But it is possible with NO special tools, except a torque wrench for reinstrallation of hubnut, tie rod end, and lower ball joint bolt.
Are you a good mechanic??
Good luck!
What is the paint code for a rover 216sli?
Sounds like wheel bearings have gone.Does the Nissan Titan 5.6L V-8 have timing belt(s) or timing chain(s)?
It is that French autoworker that was trapped under the dash while the car was being assembled...please release him.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.